Cisco 3800 Series Datasheet - Page 4
Browse online or download pdf Datasheet for Wireless Access Point Cisco 3800 Series. Cisco 3800 Series 8 pages. Password recovery procedure
Also for Cisco 3800 Series: Application Note (41 pages), Troubleshooting Manual (15 pages), Datasheet (20 pages), Quick Start Manual (40 pages), Configuring (32 pages), User Manual (7 pages)
Print Page
Feature
Alarm Detection
Relevant Management Information
Base (MIB) Support
Remote Management
Signaling Debugging
HARDWARE SPECIFICATIONS
Table 4 shows the hardware specifications for the Cisco E1/T1 ISDN PRI Network Module.
Table 4.
Hardware Specifications for the Cisco E1/T1 ISDN PRI Network Module
Feature
Dimensions (H x W x D)
Operating Temperature
Nonoperating Temperature
Relative Humidity
LEDs
Important notices, privacy statements, and trademarks of Cisco Systems, Inc. can be found on cisco.com.
Description
•
Controller local loopback
•
Controller remote loopback
CSU loopback modes for T1 CSU
•
Data terminal equipment (DTE) loopback
•
Network loopback
•
Payload loopback
•
V.54
•
Yellow Alarm—Receive/Send from/to network
•
Blue Alarm—Receive alarm indication signal (AIS) from network
•
Red Alarm—Loss of network signal
•
RFC1406-MIB
•
CISCO-ICSUDSU-MIB
•
Supported by Cisco WAN Access Performance Management System (WAPMS)
•
Cisco Intelligence Engine (IE2100)
•
CiscoWorks
•
CAS debugs
•
ISDN Q.921 and Q.931 decode
•
All other previously existing applicable Cisco IOS debugs
Description
•
1.55 x 7.10 x 7.2 inches
•
3.9 x 18.0 x 18.3 centimeters
32 to 104° F (0 to 40° C)
–40 to 185° F (–40 to 85° C)
5-95% non-condensing
LEDs per port
•
T1: T1 mode selected
•
E1-BAL: E1 balanced mode selected
•
E1-UNBAL: E1 unbalanced mode selected
•
CD: Carrier detect
•
LP: Loop condition present
•
RA: Remote alarm detected
•
LA: Local alarm detected
© 2005 Cisco Systems, Inc. All rights reserved.
Page 4 of 8