CABASSE SWELL Owner's Manual - Page 6

Browse online or download pdf Owner's Manual for Speakers CABASSE SWELL. CABASSE SWELL 12 pages.

Print Page

BLUETOOTH® TECHNOLOGY

a) Press Power button 1 to switch the speaker on.

b) Briefly press the Bluetooth button: LED flashes blue.

c) Activate the Bluetooth function in your mobile device's settings.

d) Press and hold the Bluetooth button for approximatively 2 seconds.

The LED flashes white and you'll hear a voice message: "Bluetooth pairing".

e) Search and select SWELL in the list of nearby Bluetooth devices on your

mobile device.

f) If a password is required by the mobile device, enter the number "0000"

and confirm.

g) Your device and SWELL are connected when the LED turns a steady blue

and you hear the voice message "connected".

Note: To connect additional Bluetooth® enabled mobile devices to your

SWELL, repeat steps "c" through "g". The SWELL will save the last five Blue-

tooth® devices connected. A maximum of two of these can be connected to

the SWELL at the same time (not in True Wireless mode). This means that a

third mobile device can only be used when one of the currently connected

devices is disconnected. Normally the volume of SWELL is synchronized with

your mobile device, but that depends on the individual device.

10 10

INSTANT NFC BLUETOOTH CONNECTION

If your Bluetooth® enabled mobile device supports NFC technology, you can use this to

easily connect to SWELL:

a) Switch on the SWELL by pressing the power button.

b) Activate the NFC function on your mobile device.

c) Press the Bluetooth® button on the SWELL (LED flashes blue).

d) Place the mobile device equipped with NFC on the NFC sensor located on the right side

of SWELL until a connection request appears.

e) Remove the Bluetooth® device and confirm the connection request. If you are asked for

a password, enter the number "0000" and confirm.

f) Your device is connected when the LED is a steady blue and you hear the voice message

"connected".

Note: To disconnect the Bluetooth® connection via NFC, place your mobile device equipped

with NFC on the NFC sensor of the SWELL until you hear the voice message "disconnected".

This function may not be fully supported, depending on the individual device.

Password:

0000

AUX

V-

V+

NFC SENSOR