Cisco AIR-AP1800I-Z-K9 Getting Started Manual - Page 18

Browse online or download pdf Getting Started Manual for Wireless Access Point Cisco AIR-AP1800I-Z-K9. Cisco AIR-AP1800I-Z-K9 43 pages.

Print Page

Deploying the Access Point on the Wireless Network

After you have mounted the access point, follow these steps to deploy it on the wireless network:

Step 1

Connect and power up the access point.

Observe the access point LED (for LED descriptions, see

Step 2

section on page

a. When you power up the access point, it begins a power-up sequence that you can verify by

observing the access point LED. If the power-up sequence is successful, the discovery and join

process begins. During this process, the LED blinks sequentially green, red, and off. When the

access point has joined a controller, the LED is chirping green if no clients are associated or

green if one or more clients are associated.

b. If the LED is not on, the access point is most likely not receiving power.

c. If the LED blinks sequentially for more than 5 minutes, the access point is unable to find its

primary, secondary, and tertiary Cisco wireless LAN controller. Check the connection

between the access point and the Cisco wireless LAN controller, and be sure the access point

and the Cisco wireless LAN controller are either on the same subnet or that the access point

has a route back to its primary, secondary, and tertiary Cisco wireless LAN controller. Also,

if the access point is not on the same subnet as the Cisco wireless LAN controller, be sure that

there is a properly configured DHCP server on the same subnet as the access point. See the

"Configuring DHCP Option 43" section on page 24

Reconfigure the Cisco wireless LAN controller so that it is not the Master.

Step 3

A Master Cisco wireless LAN controller should be used only for configuring access

Note

points and not in a working network.

19).

"Checking the Access Point LED"

for additional information.