Cisco AIR-LAP1310G Mounting Instructions - Page 7

Browse online or download pdf Mounting Instructions for Wireless Access Point Cisco AIR-LAP1310G. Cisco AIR-LAP1310G 40 pages. Cisco aironet 1300 series lightweight outdoor access point

Print Page

1. Mounting the Access Point

Deploying Lightweight Access Points on the Wireless Network

Prior to beginning the actual lightweight access point deployment, perform these tasks:

•

Choosing a Mounting Location

Choosing a good mounting location for the access point is important because it affects the reliability of

the wireless link and maximum data rates it can support. The most important considerations are distance

between wireless devices and clearance from obstacles. The mounting location can be a wall, ceiling,

the top or side of a building, or on a tower providing a clear unobstructed line-of-sight to the wireless

devices.

With the integrated antenna access point configuration, the location must allow the access point to be

oriented in the proper direction.

With the external antenna access point configuration, the external antenna must be located within

line-of-sight of the wireless devices. The access point can be located in a convenient location that

minimizes the cable length to the antenna.

To meet regulatory restrictions, the external antenna access point and the external antenna must be

Note

professionally installed. The network administration or other IT professional responsible for installing and

configuring the unit is a suitable professional installer. Following installation, access to the unit should be

password protected by the network administrator to maintain regulatory compliance.

Signal Path Distance

In an environment without obstacles in the signal path, the maximum operating distance depends

primarily on the type of antennas and the free space loss between the access point and wireless devices.

Make sure your proposed mounting site is within range of the wireless devices.

When operating as an access point, the maximum communication distance is approximately 1 mile.

Note

78-17634-01

Ensure that a site survey has been performed.

Ensure that your network infrastructure devices are operational and properly configured.

Ensure that your controllers are connected to switch trunk ports.

Ensure that your switch is configured with untagged access ports for connecting your access points.

Ensure that a DHCP server with Option 43 configured is reachable by your access points or

manually configure the controller information in the access point (for additional information, refer

to the Cisco Aironet 1300 Series Outdoor Access Point/Bridge Hardware Installation Guide).

Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions

Deploying Lightweight Access Points on the Wireless Network