DigitaLinx DL-HD2100 Quick Install Manual - Page 4
Browse online or download pdf Quick Install Manual for Extender DigitaLinx DL-HD2100. DigitaLinx DL-HD2100 8 pages. Hdbaset extender set
Also for DigitaLinx DL-HD2100: Quick Install Manual (8 pages), Owner's Manual (17 pages)
Print Page
1.
FRONT PANEL DIAGNOSTIC LEDs;
• POWER -Solid, the DL-HD2100 extender is receiving power from the power supply or from the remote extender
via Category 6 cabling.
• STATUS - Flashes once per second, the HDBaseT processor is running.
• HDCP - Solid, HDCP signal is present in the HDMI stream. Flashes quickly, non-encrypted HDCP signal is present
in the HDMI stream.
• LINK - Solid, the two DL-HD2100 components are communicati ng via Category cabling.
2.
DC 12V
• Locking power port, connect DC12V power adapter to receiver (either power port on transmitt er and receiver
can power enti re set)
3.
HDBT IN
• RJ45 HDBaseT connecti on. Connect Cat6 cable to transmitt er
4.
IR In / IR OUT
• 3.5mm IR input port for connecti on to IR receiver or IR system
• 3.5mm IR output port for connecti on to IR emitt er
5.
AUDIO CONTROL
• ARC - When ARC mode is selected, an HDMI cable from the HDMI OUT should connect to an ARC compati ble
input on a display, digital audio will then de-embed from the TOSLINK OUT on the DL-HD2100 transmitt er
• TOSLINK - When TOSLINK mode is selected, a Toslink cable should be connected from the displays digital audio
output to the TOSLINK IN on the DL-HD2100 receiver, digital audio will then de-embed from the TOSLINK OUT
port of the DL-HD2100 transmitt er
6.
RS232
• 3 pin Phoenix connector port for connecti ng / passing RS232 control from transmitt er locati on
7.
HDMI In
• HDMI input port for connecti ons to video sources
8.
Ethernet
• RJ45 port for passing Ethernet from transmitt er
9.
TOSLINK IN
• Digital audio return channel input port for injecti ng digital audio signal from display (only in TOSLINK mode)
Receiver
1
2
3
4
5
6
7
8
9