Cisco Aironet 1300 Series Quick Start Manual - Page 15
Browse online or download pdf Quick Start Manual for Wireless Access Point Cisco Aironet 1300 Series. Cisco Aironet 1300 Series 35 pages. Outdoor access point/bridge
Also for Cisco Aironet 1300 Series: Datasheet (15 pages)
Print Page
Caution
Do not interrupt the boot process or the configuration file will
be damaged. Wait until the access point/bridge Install Mode
LED begins to blink green before continuing with CLI
configuration changes. You will see the following CLI message
when the load process has finished: Line protocal on Interface
Dot11Radio0, changed state to up.
5. After the access point/bridge reboots, you can reconfigure it with the
Web-browser interface or the CLI.
The access point/bridge is configured with the factory default values
including the IP address (set to receive an IP address using DHCP). To obtain
the access point/bridge's new IP address, you can use the show interface bvi1
CLI command.
Quick Start Guide Cisco Aironet 1300 Series Access Point
15