DigitaLinx DL-HDE100 Owner's Manual - Page 10

Browse online or download pdf Owner's Manual for Transmitter DigitaLinx DL-HDE100. DigitaLinx DL-HDE100 16 pages. Extender set transmits hdmi, bidirectional ir, rs232 and ethernet up to 100 meters away using a single category 6 twisted pair cable.
Also for DigitaLinx DL-HDE100: Installation Manual (4 pages), Quick Install Manual (8 pages)

Print Page

DL-HD70 Owners Manual

Connecting IR Control

The DL-HDE100 is capable of transmitting bi-directional IR signals through the HDBaseT circuit. The DL-HDE100

comes with 2 IR receivers (eye) and 2 IR emitters (flashers) so you can control devices from either end of the

extender circuit.

Passing IR Signals:

The

any of the electronics, the extenders should be powered off while inserting or removing any IR

components. Inserting an IR transmitter into the IR IN port may damage the IR circuit for that

extender.

Source Device Control using IR

Attach the IR emitter to the IR receiver of the source device, insert the TS 3.5 mm plug of the emitter to the

IR OUT port of the DL-HDE100 transmitter. Insert the TS 3.5 mm plug of the IR receiver (eye) to the IR IN port

of the DL-HDE100 receiver. Point the source device IR remote at the display location where the IR receiver is

located, IR signals will now travel through HDBaseT to the DL-HDE100 transmitter side where the IR emitter is

attached to the source device.

Remote Display using IR

Attach the IR emitter to the IR receiver of the display device, insert the TS 3.5 mm plug of the emitter to the IR

OUT port of the DL-HDE100 receiver. Insert the TS 3.5 mm plug of the IR receiver (eye) to the IR IN port of the

DL-HDE100 transmitter. Point the source device IR remote at the source device location where the IR receiver

is located, IR signals will now travel through HDBaseT to the DL-HDE100 receiver side where the IR emitter is

attached to the display device.

Source / Display Control from Control System

To pass 3rd party IR system signals through the DL-HDE100, such as a control system, connect the TS connec-

tor of the IR-AC coupling cable (provided) to the IR output port of the control system and connect the TRS

connector of the IR-AC cable to the IR IN to either transmitter or receiver of the DL-HDE100.

To DL-HD70

Tx or Rx Extender IR Input

DL-HDE100

is capable of passing IR signals between 33 and 55 KHz. To prevent damage to

Tip: +5V DC

Ring: IR Signal

Sleeve: Ground (GND)

IR Signal

Note: Voltage on Tip from RX may be diﬀernt for non Liberty Devices

+5V DC Lifted

Ground (GND)

Sleeve: Ground (GND)

Tip: IR Signal

To Control system or

IR hub output