Epson AcuLasaer C1900 Quick Reference Manual - Page 7

Browse online or download pdf Quick Reference Manual for All in One Printer Epson AcuLasaer C1900. Epson AcuLasaer C1900 17 pages.

Print Page

Replace Waste T Box

The waste toner collector is full of toner.

Replace it with a new waste toner collector.

See "Replacing the waste toner collector" in

the Reference Guide.

The error clears itself after you have replaced

the waste toner collector and close the front

cover.

Reserve Job Canceled

The printer cannot store the data of your

print job using the Reserve Job function. The

maximum number of print jobs stored in the

printer's Hard Disk Drive has been reached,

or the drive has no more memory available

to store a new job. To store a new print job,

delete a previously stored job. Also, if you

have any Confidential Jobs stored, printing

those jobs will make more memory

available.

To clear this error, select Clear Warning

from the control panel's Reset Menu. See

"How to access the control panel menus" for

instructions.

Reset

The printer's current interface has been reset

and the buffer has been cleared. However,

other interfaces are still active and retain

their settings and data.

Reset All

All printer settings have been reset to the

default configuration, or to the last settings

that were saved.

Reset to Save

A control panel menu setting was changed

while the printer was printing. Press the

Start/Stop button to clear this message. The

setting will become effective after printing

has finished.

EPSON AcuLaser C1900 Quick Reference

ROM Check

The printer is checking the ROM.

Self Test

The printer is performing a quick internal

check.

Service Req xyyy

A controller error or a print engine error has

been detected. Turn off the printer. Wait at

least 5 seconds and then turn it back on. If

the error message still appears, write down

the error number listed on the LCD panel

(xyyy) and turn off the printer, unplug the

power cord, and contact a qualified service

representative.

Sleep

The printer is in sleep mode.

Unable Clear Error

The printer cannot clear an error message

because the error status still remains. Try

solving the problem again.

Warming Up

The printer is warming up.

Waste T BoxNearfull

The waste toner collector is nearly full of

toner. You can continue to print until the

Replace Waste T Box error message

appears, but early replacement is

recommended to maintain high print

quality. See "Replacing the waste toner

collector" in the Reference Guide.

Status and Error Messages (6/7)