Cisco ASR1006 - ASR 1006 Modular Expansion Base Hardware Installation Manual - Page 25
Browse online or download pdf Hardware Installation Manual for Wireless Access Point Cisco ASR1006 - ASR 1006 Modular Expansion Base. Cisco ASR1006 - ASR 1006 Modular Expansion Base 47 pages. Lightweight access points
Also for Cisco ASR1006 - ASR 1006 Modular Expansion Base: Deployment Manual (40 pages)
Print Page
Start the System
After installing your Cisco ASR 1006 Router and connecting cables, start the router as follows.
Check for the following:
Step 1
• Make certain that each shared port adapter is firmly seated in its subslot and its captive screws are securely tightened.
• The Cisco ASR1000-ESP10 or Cisco ASR1000-ESP20 embedded services processors in the Cisco ASR 1006 router are
inserted in slot F0 and F1, is firmly seated in its slot, and its captive screws are securely tightened.
• All network interface cables are connected.
• The console terminal is turned on.
Turn on power. The green OK LED on the power supply turns on.
Step 2
Listen for the fans; you should immediately hear them operating.
Step 3
Step 4
During the boot process, observe the power LEDs. The power LED should be green on all boards. The Status LED lights
yellow to indicate booting and then green when IOS is running.
Table 1
provides information about the LEDs as the system starts.
Table 1
Cisco ASR 1006 Router LED Activity
LED Label
LED
PWR
Power
STAT
System status
ACTV
Active
STBY
Standby
CRIT
Critical
MAJ
Major
MIN
Minor
DISK HD
Internal Hard Drive
DISK USB
External USB FLASH
DISK BF
Internal FLASH (BootDisk)
During the boot process, observe the system LEDs. The STAT LED comes on immediately as yellow, then turns to green
when the Cisco IOS is booted. The shared port adapter LEDs go on and off irregularly.
The system boots differently depending on the configuration that ships with your system. This output is only an
Note
example of what can display.
Color
In the Power Up State -Behavior Description
Solid green
All power requirements are within specification
Off
Off, the router is in standby mode.
Solid green
Cisco IOS has successfully booted.
Yellow
BOOT ROM has successfully loaded.
Red
System failure.
Green
Lit when this is the active ASR 1000 Series route processor
(Cisco ASR1000-RP1 or Cisco ASR1000-RP2).
Yellow
Lit when this is the standby ASR 1000 Series route
processor.
Solid red
Critical alarm indicator. This is on at power up, turned off
by software.
Solid red
Major alarm indicator.
Amber
Minor alarm indicator.
Flashing green
Active indicator.
Off
No activity.
Flashing green
Active indicator.
Off
No activity.
Flashing green
Active indicator.
Off
No activity.
25