ACU-RITE 02033 Instruction Manual - Page 6

Browse online or download pdf Instruction Manual for Weather Station ACU-RITE 02033. ACU-RITE 02033 13 pages. Professional weather center

Print Page

Placement for Maximum Accuracy

AcuRite sensors are sensitive to surrounding environmental conditions. Proper

placement of both the display and the sensor are critical to the accuracy and

performance of this product.

Display Placement

Place the display in a dry area free of dirt and dust. To ensure

accurate temperature measurement, place out of direct sunlight

and away from heat sources or vents. Display stands upright for

tabletop use or is wall-mountable.

5-in-1 Sensor Placement

The 5-in-1 sensor is designed to remain outdoors all year long.

Choose an open location with no obstructions above or around

the sensor for the most accurate measurements.

Important Placement Guidelines

Display and sensor must be within 330 ft (100 meters) of each other.

MAXIMIZE WIRELESS RANGE

Place units away from large metallic items, thick walls, metal surfaces, or other

objects that may limit wireless communication.

PREVENT WIRELESS INTERFERENCE

Place both units at least 3 ft (0.9 meters) away from electronic devices (TV,

computer, microwave, radio, etc.).

LOCATE AWAY FROM HEAT SOURCES

Position sensor away from heaters, air conditioners, chimneys, exhaust vents,

asphalt and concrete (surfaces that radiate heat).

LOCATE AWAY FROM HUMIDITY SOURCES

Avoid installing the sensor near pools, spas, or other bodies of water. Water

sources may impact humidity accuracy.

LOCATE AWAY FROM SPRINKLER HEADS

DO NOT install the sensor where it will be sprayed by a sprinkler system. This

may force water inside the sensor.

LOCATE AWAY FROM WIND & RAIN OBSTRUCTIONS

DO NOT mount the sensor with obstructions around it.

Consider a location that is a wide open area, with few

structures around to ensure accurate wind measurement.

Visit us online to view installation photos and

video, or learn more about AcuRite technology:

www.AcuRite.com/5in1

View Video

5-in-1 Sensor Installation Guidelines

INSTALLATION HEIGHT

Mount the sensor at a minimum height of 5 feet

(1.5 meters) off the ground, in an open area. Higher is better for wind

measurements - the National Weather Service recommends 33 feet

(10 meters) high!

MOUNTING OPTIONS

The included mounting bracket is designed to screw

directly onto wooden posts or surfaces that are 2"x 4" or larger. The sensor

can also be mounted directly to 3/4" steel pipe (available at hardware stores

and home centers).

SOLAR CELL INSTALLATION

Install the sensor

with the solar cell facing SOUTH. This ensures

the cell receives as much sun as possible and

orients wind direction.

5-in-1 Sensor Installation

1. Fasten mounting base (included) to a post

or pole (not included) using the 4 longer

screws included in the hardware bag.

2. Insert the mounting base into the hole on

the bottom of the sensor.

3. Make sure the arrows on the top of the

sensor are pointed in the proper direction

and the bubble level is centered. The

solar cell should be facing south to

properly orient the wind direction.

4. Fasten the sensor into the mounting base

using the 2 shorter screws included in the

hardware bag.

The 5-in-1 sensor is now ready to use.

Clear Data Collected During Installation

When installation is complete, clear erroneous data from the display by

pressing and HOLDING the "Reset" button on the back of the display inside

the battery compartment. This button will clear all records.

Basic Setup is Complete

The 5-in-1 sensor will now synchronize with the display. It may take a few

minutes for synchronization to complete. If both or one of the units appear to

be functioning improperly, please refer to the troubleshooting section.

NO OBSTRUCTIONS

ABOVE OR AROUND

T H

S O U

(1.5 meters)