Cisco Meraki MR46E Installation Manual - Page 13

Browse online or download pdf Installation Manual for Wireless Access Point Cisco Meraki MR46E. Cisco Meraki MR46E 19 pages.

Print Page

4. Attach the mount cradle to the T-rail clips using the mount cradle holes (marked with a "T").

Tip: Pre-assemble rubber spacers and screws to the mount cradle. The mount cradle can then be held with one hand

while the other hand holds a screwdriver. If mounting your AP to a dropped ceiling, skip to the "Power the AP" section.

Electrical Junction Box Mount Using Mount Cradle

The access point can be mounted to a 4" square cable junction box, a 3.5 or 4" round cable junction box, or various U.S.

and European outlet boxes (mounting screws are not included).

Using appropriate mounting hardware for your specific type of junction box, attach the mount cradle to the junction box.

Getting Power to the AP

If mounting to an electrical junction box, feed the Ethernet cable through the cable access hole in the mount cradle. If

mounting to a wall or ceiling, the Ethernet cable will feed from behind the AP. The

"Power Source

Options" section of

this document lists the different powering options and their unique characteristics.

Attach the MR46E AP to the Mount Cradle

(This section applies to wall and/or solid ceiling, drop ceiling or electrical junction box mount where you have already

installed the mount cradle.)

The MR46E AP attaches to the mount cradle with two tabs on the cradle that insert into the MR46E AP, and is secured

to the cradle using one screw.

To attach the MR46E AP to the mount cradle properly, line up the top edge of the AP with the top tab of the mount

cradle. Since the cradle is already mounted to the wall, guide the MR46E AP towards the top tab and insert the top tab