Cisco Meraki MR76 Installation Manual - Page 16

Browse online or download pdf Installation Manual for Wireless Access Point Cisco Meraki MR76. Cisco Meraki MR76 27 pages.

Print Page

Reminder: Since the MR76 requires one antenna for each band please ensure that the antennas are aimed in the same coverage area.

Antenna selection

Meraki offers a number of antenna options for the MR76 access point. The MR76 features dual band antenna ports thus dual band antennas should be

paired with the AP. Below is a highlight of the different antenna types and their applications. It is always best practice to consult with a Cisco SE or

Partner in to select the best antenna for the unique design.

Omni Directional

Omni directional antennas are best for pole mounts applications and for mesh networks. Use omni directional antennas when designing to cover 360

degrees around the Access Point.

Sector Antenna

Sector antennas are ideal for building mounts as they target the signal away from the interior spaces of the building and focus the energy to the larger

outdoor space. This antenna is ideal for exterior building use but may also be used for some mesh network designs.

Patch Antenna

Patch antennas are ideal for Access points mounted on a high ceiling and is intended to cover a large space. This antenna is ideal for warehouses.

Stadium Patch Antenna

A stadium patch antenna is ideal for a high density AP deign with expected high user per sqft. Examples of this are in stadiums where 1 AP is designed

to cover a section and a event center where there is high user per sqft.

Please select the right antenna in Dashboard when adding the MR76 to a network. Maximum TX power will depend on the antenna selection made in

Dashboard.

Aim Antennas

If you are using directional antennas, aim them appropriately to ensure optimal performance for your specific network topography. Omnidirectional

antennas perform best in a mesh network when oriented vertically. Patch and sector antennas should be angled in the direction of the desired coverage

area.

Attach Antennas

Remove protective plastic covers from all four N-type RF connectors. Attach appropriate antennas (and protective boots if included).

Power the MR76

1. Route the Ethernet cable from the PoE Injector "OUT" port or from a PoE enabled switch to the MR76.

2. Install a Cable Gland on the MR76 end of the cable.