Cisco WAP131 Quick Start Manual - Page 7

Browse online or download pdf Quick Start Manual for Wireless Access Point Cisco WAP131. Cisco WAP131 13 pages. Reboot and reset factory default settings
Also for Cisco WAP131: Quick Start Manual (13 pages), Manual (4 pages), Manual (4 pages)

Print Page

Follow the Setup Wizard instructions to finish the WAP device

TEP

installation. The Setup Wizard turns on the Wi-Fi radio, which

allows you to connect wirelessly.

We strongly recommend that you use the Setup Wizard for the first

installation. For more advanced configurations, see the

Administration Guide. A link to the Administration Guide is found in

"Where to Go From

Congratulations, you can now start using your Cisco WAP131.

Suggested Next Steps

In case of an error while installing, try the troubleshooting procedures

described in this section.

Troubleshooting

If you cannot display the configuration utility, you can test the ability of the

computer to communicate with the Cisco WAP131 by using ping. To use

ping on a computer running Windows:

Verify that the Cisco WAP131 is powered on and the lights indicate

TEP

the appropriate links.

Locate the Cisco WAP131's IP address. While there are different

TEP

ways to locate the IP address, this procedure uses Cisco FindIT.

If you have previously downloaded Cisco FindIT, open Internet

Explorer and launch Cisco FindIT. For more information on

downloading Cisco FindIT, see www.cisco.com/go/findit.

b. In the Cisco FindIT display, place your mouse over the Cisco

WAP131's name. The Cisco WAP131's IP address is displayed

along with other device information.

Open a command window by choosing Start > Run and enter

TEP

cmd.

At the command window prompt, enter ping and the Cisco

TEP

WAP131's IP address. In this example, we pinged 192.0.2.10.

If successful, you should get a reply similar to the following:

Pinging 192.0.2.10 with 32 bytes of data:

Reply from 192.0.2.10: bytes=32 time<1ms TTL=128

Cisco WAP131 Quick Start Guide

Here".