digitalview IE-1000 Manual - Page 6

Browse online or download pdf Manual for Computer Hardware digitalview IE-1000. digitalview IE-1000 20 pages. Image enhancer add-on board

Print Page

CONNECTION & OPERATION

CAUTION: Never connect or disconnect parts of the display system when the system is powered up

as this may cause serious damage.

CONNECTION

Connection and usage is quite straight forward (it is useful to have the relevant connection diagram

available at this time):

1. Connect the LCD panel & IE-1000 : Use the appropriate panel cable as indicated in the relevant

Digital View Connection Diagram.

2. Connect the Digital View main controller & IE-1000: Use LVDS cable P/N 426497600-3,

200mm, this carries both the LVDS signal and panel power.

3. Connect a suitable OSD switch mount kit : Digital View offer a number of ready made options.

4. Check all Jumpers & Switches: Refer to the relevant Digital View Connection Diagram or the

jumpers and switches setting table (in the following section).

5. Connect the Power supply : Plug a DC 12V/24V power source to the connector PP1 or

PP2/PP3. You can consider to use Digital View mating power cable P/N 426013800-3, 160mm for

PP1 connection.

6. Power on : Switch on the controller board and panel by using the OSD switch mount.

Power status on LED5A :

State

Power on state

Board status LED on LED1A :

State

Board in operation with valid

signal.

No signal state

Valid signal detected and

board setup in progress

General:

•

If you are using supplied cables & accessories, ensure they are correct for the model of panel and

controller and IE-1000.

•

If you are making your own cables & connectors refer carefully to both the panel & inverter

specifications and the section in this manual, "Connectors, Pinouts & Jumpers" to ensure the

correct pin to pin wiring.

Specifications subject to change without notice

LED color

Green

LED color

GREEN

RED

ORANGE

6 of 19

Page