Cisco WAP571E Quick Start Manual - Page 15
Browse online or download pdf Quick Start Manual for Wireless Access Point Cisco WAP571E. Cisco WAP571E 17 pages. Manually connect access points to the network via power over ethernet (poe)
Also for Cisco WAP571E: Manual (4 pages), Quick Start Manual (6 pages)
If the wireless access points do not receive a DHCP response (there is no
DHCP server on your network) after 60 seconds, the access points will
fallback to the following default static IP address: 192.168.1.245 and a
default mask of 255.255.255.0. To reach that IP address, be sure that your
computer is on the 192.168.1.xxx network.
Rebooting the Devices or Returning them
8
to their Factory Default Settings
To reboot your device:
• The Cisco WAP571 uses PoE power supply; unplug your Ethernet
connection and plug it back in.
or
• With the power on, press the Reset button with an opened paper clip
for less than three seconds, or until the lights go off.
–
Release the Reset button as soon as the lights go off, or you will
restore the device to factory default settings and lose your
configurations.
–
Release the Reset button when the system light turns on.
To reset the device to factory default settings:
• With the power on, press and hold the Reset button with an opened
paper clip for more than 10 seconds. The system light will go off.
Where to Go From Here
Support
Cisco Support
Community
Cisco Support and
Resources
Phone Support Contacts
Cisco WAP571E Wireless Access Point
www.cisco.com/go/smallbizsupport
www.cisco.com/go/smallbizhelp
www.cisco.com/en/US/support/
tsd_cisco_small_business
_support_center_contacts.html
14