Cisco Wap581 Quick Start Manual - Page 3
Browse online or download pdf Quick Start Manual for Wireless Access Point Cisco Wap581. Cisco Wap581 14 pages. Reboot and reset to factory default settings
Also for Cisco Wap581: Quick Start Manual (17 pages), Manual (10 pages)
Print Page
Cisco WAP581 Wireless-AC/N Premium
2
Dual Radio Access Point with PoE Setup
Features
Front Panel
The front panel of the device consists of a single system LED. For a full
description of the colors of the light and its indications, see
Hardware
Installation.
Back Panel
The back panel of the device has two RJ-45 Ethernet ports. Facing the
back of the device, the right port (labeled "ETH0/PD") is an 2.5GbE with
802.3at & 802.3af Power over Ethernet (PoE) port which is used to power
your device. The left port (labeled "ETH1") is a general Gigabit Ethernet
LAN interface. Both are auto-sensing, Gigabit Ethernet (802.3) ports used
to connect your WAP devices to network devices, such as computers,
routers, or switches. We strongly recommend that you use a Category
5e or better cable for Gigabit connectivity.
Side Panel
The side panel of the device consists of the following:
• Kensington Lock Slot—Helps to secure the unit physically using a cable
attached to the device.
• Reset button—See
Factory Default Settings
Default Setting
Parameter
Username
Password
LAN IP Address
Fallback LAN IP
Subnetwork Mask
If you are using a Cisco RV Series router, the default range for the DHCP
assigned address is from 192.168.1.100 to 192.168.1.254. Any device
connecting to the same LAN will be assigned an IP address in this range.
Cisco WAP581 Wireless Access Point
Rebooting the Devices or Returning them to their
for information on the Reset button.
Default Value
cisco
cisco
DHCP address assigned
by server
192.168.1.245
255.255.255.0
Verifying the
2