Cisco Wap581 Quick Start Manual - Page 3

Browse online or download pdf Quick Start Manual for Wireless Access Point Cisco Wap581. Cisco Wap581 17 pages. Reboot and reset to factory default settings
Also for Cisco Wap581: Quick Start Manual (14 pages), Manual (10 pages)

Print Page

Power over Ethernet (PoE) port which is used to power your device. The left port

(labeled "ETH1") is a general Gigabit Ethernet LAN interface. Both are auto-sensing,

Gigabit Ethernet (802.3) ports used to connect your WAP devices to network devices,

such as computers, routers, or switches. We strongly recommend that you use a

Category 5e or better cable for Gigabit connectivity.

Side Panel

The side panel of the device consists of the following:

• Kensington Lock Slot—Helps to secure the unit physically using a cable

attached to the device.

• Reset button—See

Default Settings, page10

Default Setting

Parameter

Username

Password

LAN IP Address

Fallback LAN IP

Subnetwork Mask

If you are using a Cisco RV Series router, the default range for the DHCP assigned

address is from 192.168.1.100 to 192.168.1.254. Any device connecting to the same

LAN will be assigned an IP address in this range.

If your network does not have an existing DHCP server, the WAP581 will start a

DHCP server for WLAN stations and stop the DHCP client when WAP581 is in factory

default. The DHCP server will assign the IP address from 192.168.1.20 to

192.168.1.100.

Mounting the Cisco WAP581 Wireless-AC/ N

Premium Dual Radio Access Point with PoE Setup

You can place your access point on a desktop, or mount it on a wall or ceiling.

Cisco WAP125 Quick Start Guide

Rebooting the Devices or Returning them to their Factory

for information on the Reset button.

Default Value

cisco

DHCP address assigned by

server

192.168.1.245

255.255.255.0