CABINETS TO GO Findley & Myers DC230 Assembly Instructions - Page 2

Browse online or download pdf Assembly Instructions for Indoor Furnishing CABINETS TO GO Findley & Myers DC230. CABINETS TO GO Findley & Myers DC230 5 pages. 2 drawer base cabinet
Also for CABINETS TO GO Findley & Myers DC230: Assembly Instructions Manual (8 pages)

Print Page

► General Instructions:

Thank you for purchasing a Cabinets To Go product. You are now the proud owner of a high quality product designed

to face the test of daily use and guaranteeing your enjoyment for many years to come.

Carefully read the instructions before starting the installation.

During assembly, please follow all generally accepted safety procedures.

Failure to adhere to the following instructions will invalidate the warranty and Cabinets To Go will decline any responsibility for any

damages caused. Any installation which does not correspond to the instructions may result in defects, malfunctioning parts, significant

damage and/or injury.

Before the assembly begins, check that all appropriate and required plumbing and electrical connections exist.

Before drilling, make absolutely sure that there are no pipes (gas, water,electricity, heating, etc.) at the drilling location. Cabinets To Go will

not be held responsible for failure to follow these instructions.

PRIOR TO ASSEMBLY, PLEASE MAKE SURE YOU HAVE ONE FACE FRAME BOX AND ONE CARCASS BOX, WHICH HAVE ALL THE PARTS IN THE

QUANTITIES MENTIONED BELOW. IF YOU ARE MISSING ANY PARTS, PLEASE STOP AND CONTACT CUSTOMER CARE IMMEDIATELY AT

1-800-CABINET.

Items Quantity

►

Item

Description

Face Frame

Side Panels

Bottom Panel

Back Panel

Toe Kick

Drawer Fronts

Drawer Boxes:

Hardware Box:

Bumpers 8pcs, Plastic corner bracket 4pcs, 1/2" round head screws 8pcs, 1/2" flat head screws for slides 12pcs

1" screw 12pcs, Slide Rails 2 Sets, Slide Rail Supports 4pcs

► Required Tools:

Tools Required: Phillips Screwdriver

Optional Tools: Electric Drill

► Hardware Box:

Qty

Q ty

Qty

The materials listing above are for the largest unit in this instruction set. Smaller units may require less hardware and materials;

therefore, your item may contain a smaller number of each.

Front 3pcs, Back 3pcs, Sides 6pcs, Bottom 3pcs

Optional Tools: Rubber Mallet

Qty

4 - (2 Sets)

Qty

Page 2

Qty