Filtrine B103 Maintenance Instructions

Browse online or download pdf Maintenance Instructions for Water System Filtrine B103. Filtrine B103 2 pages. Hands-free bottle filling station

Print Page
Sensor Activated B103
Maintenance Instructions
To remove the cover plate, unscrew the Jackman
screws from both sides and slide the cover plate out.
Cartridge Regulator Replacement and Flow
Adjustment:
Turn off water to the fixture and depress button on
cartridge regulator to drain water left in the line.
Using the spanner wrench or needle nose pliers,
unscrew the brass regulator retaining ring.
Gently wiggle cartridge back and forth to remove it
from the brass valve assembly body.
Check to ensure that the old neoprene seal was also
removed. Install new neoprene seal on the new
cartridge regulator and install new assembly into the
valve body, ensuring inlet and outlet holes on the
cartridge are lined up and the cartridge is seated
properly in the valve body.
Reinstall the regulator retaining ring and tighten using
the spanner wrench or needle nose pliers.
Turn on water to fixture and test for flow and leaks by
pushing plunger with flat screwdriver.
Adjust the flow by turning the white screw head on the
cartridge regulator. Turn it clockwise to decrease flow
and counterclockwise to increase flow.
Sensor Adjustment:
To adjust the distance of the sensor intensity, turn
yellow phillips head screw on control module circuit
board clockwise to lengthen distance and counter
clockwise to shorten it.
Bottle Counter Reset:
To reset the bottle counter, press and hold the black
reset button (see diagram above for location) for a few
seconds while passing hand across the sensor.
Cartridge Regulator Valve Assembly
Exploded View
Spanner
Neoprene
Wrench
Seal
Cartridge Regulator
Brass Retaining Ring
See B103 FLUSH BUTTON INSTALL [EB] for valve assembly
part numbers
Filtrine Mfg. Co. ∙ 15 Kit St. Keene, NH 03431 USA
800-930-3367 ∙ 603-352-5500 ∙ FAX (603) 352-0330
www.filtrine.com ∙ [email protected]
Hands-Free B103 Bottle Filling Station
Maintenance Instructions
Cover Plate
7
2
1
6
DRAWING
PART NO.
Valve Assembly
Body
Button Trim Ring
ASSEMBLY
ASSEMBLY
3
DESCRIPTION
1
CARTRIDGE REGULATOR ASSEMBLY
BATTERY BOX
2
AA LITHIUM BATTERIES - 4 PACK
3
CONTROL MODULE
4
SOLENOID VALVE
SENSOR (FOR B103 WITH BOTTLE
COUNTER)
5
RED LENSE
SENSOR (FOR B103 WITHOUT BOTTLE
6
COUNTER)
7
BOTTLE COUNTER, 3-30VDC
SENSOR ASSEMBLY (FOR B103 WITH
BOTTLE COUNTER) - PART NO. 2, 3, 4 & 5)
SENSOR ASSEMBLY (FOR B103 WITHOUT
BOTTLE COUNTER) - PART NO. 2, 4 & 6
1
" Stop Valve
4
(Water Inlet)
4
B103
Body
Bottle Counter
Reset Button
5
ORDER PART
NO.
45.0006
6.1712
51.0592
6.1716
6.1708
6.1714
6.1717
6.1713
6.1730
6.1709
6.1710
"HANDS-FREE" BOTTLE FILLING
STATION ASSEMBLY [EB] - PAGE 1
01/15/2020