ACU-RITE 605 Instruction Manual - Page 2

Browse online or download pdf Instruction Manual for Weather Station ACU-RITE 605. ACU-RITE 605 6 pages. Wireless weather station + companion

Print Page
2 READ
Please read this entire manual carefully before you set up the instrument and begin to
use it. In this way you can become familiar with the features of the weather station &
companion to get the most benefit from it.

3 INSTALL BATTERIES

Main Unit: Always install batteries into the main unit first. On the back of the unit,
remove the battery compartment cover. Insert 3 AA alkaline batteries. Replace the
cover.
Companion: On the back of the unit, remove the battery compartment cover. Insert 2
AAA alkaline batteries. Replace the cover.
Wireless Sensor: After batteries have been put into the main unit and companion,
remove the back cover of the wireless sensor. Insert 2 AA alkaline (or lithium) batteries.
NOTE: When replacing the batteries for the wireless sensor, remove the batteries from
the sensor and clear that sensor's channel on the main unit by pressing and holding the
CHANNEL button when the corresponding channel is displayed. Reinstall the batteries
into the wireless sensor.
Severe cold (below -4º F/-20º C) can cause alkaline
Operating Range of Batteries
batteries to freeze and function improperly. Use lithium
LITHIUM
-22ºF
158ºF
(-30ºC)
(70ºC)
BATTERIES
batteries in extremely low temperature conditions to
ALKALINE
-4ºF
158ºF
(-20ºC)
(70ºC)
BATTERIES
ensure continued operation.
4 CHOOSE WHERE TO PLACE THE MAIN UNITS and WIRELESS SENSOR
Main Unit/Companion: Choose wall mount or table-top placement.
• Choose a location for each unit that is at least 10 feet away from other electronic
devices that may interfere with the wireless signal.
• Wall mounting: Use the mounting slot on the back of each unit to hang on the wall.
• Table-top placement: Snap the base support to the main unit by inserting the support's
two barbed prongs into holes on the bottom edge of the main unit. The companion has
an integrated fold-out stand for table-top placement.
Wireless Sensor: When placing the sensor, consider these things:
• Although the sensor is designed for outdoor use, placement in a protected area will
prolong its life.
• Mounting: Use the mounting slot on the back of the unit to hang it from a wall or
vertical surface.
• The sensor must be within 100 feet (30 meters) of each of the main units.
• The sensor is resistant to weather and to water. It is NOT WATERPROOF.
• Prolonged exposure to cold weather may cause damage to the LCD panel.
• Wireless sensor must be placed outdoors to observe outdoor temperatures and
humidity.
2
Main Unit
(BACK)
1
REMOVE
BATTERY
COMPARTMENT
COVER
Wireless Sensor
(BACK)
REMOVE 4 SCREWS
1
TO OPEN BATTERY
COMPARTMENT
Placement
Wireless sensor should be
placed out of direct sunlight
and be protected from
direct weather elements.
100 feet (30m) maximum
wireless distance between
main unit/companion and
wireless sensor.
Main Unit & Companion
should be placed at least 10
feet from other electronic
devices (TV's, computers, etc.)
and both should be less than 100 feet
from the wireless sensor.
COMPANION
(BACK)
AAA
AAA
INSTALL
2
3 "AA"
BATTERIES
2
AA
AA
1
AA
AA
C/F
reset
AA
2
A
A
AA
INSTALL
2 "AA"
BATTERIES
CH
3
INSTALL
2 "AAA"
BATTERIES
REMOVE
BATTERY
COMPARTMENT
COVER