Cisco ICS-7750 Operating Manual - Page 19

Browse online or download pdf Operating Manual for Conference System Cisco ICS-7750. Cisco ICS-7750 32 pages. Hewlett-packard network router installation guide

Print Page

Chapter 5

Operating the Cisco ICS 7750

Saving Configuration Changes

Step 1

Step 2

Using Peripherals with SPE310s

78-14165-03

To prevent loss of the ASI or MRP configuration after a reboot, save the

running-config file to the startup-config file by following these steps:

Command

MRP> enable

Password: password

MRP#

MRP# copy running-config

startup-config

This section summarizes known issues and best practices regarding the use of

keyboards, mice, monitors, and the USB CD-ROM drive with SPE310s.

Consider the following issues when using peripherals with SPE310s:

USB CD-ROM drive:

•

The TEAC 210PU USB CD-ROM drive is included with the

–

Cisco ICS 7750. The TEAC 210PU USB CD-ROM drive is the only USB

CD-ROM drive that has been tested for use with SPE310s.

Do not connect or disconnect the USB CD-ROM drive while the SPE310

–

is booting. See the

section on page

USB keyboards, mice, and hubs:

•

Because the USB CD-ROM drive is required during reimaging, and

–

because the SPE310 has only two USB ports, a USB hub might be

required if you intend to connect both a USB keyboard and a USB mouse

to the SPE310, when the keyboard lacks a USB pass-through port.

For a list of USB keyboards, mice, and hubs that have been tested with

–

the Cisco ICS 7750, see the

Mouse to the SPE310" section on page

Purpose

Enters enable mode. You have entered enable

mode when the prompt changes to

Saves the configuration changes to the

startup-config file so that they are not lost during

resets, power cycles, or power outages.

"Best Practices for Using Peripherals with SPE310s"

5-20.

"Connecting a Monitor, Keyboard, and

Cisco ICS 7750 Installation and Configuration Guide

Accessing the System

MRP#

3-26.

5-19