Cisco MX Series Getting Started Manual - Page 12

Browse online or download pdf Getting Started Manual for Conference System Cisco MX Series. Cisco MX Series 34 pages. Telepresence video systems
Also for Cisco MX Series: Getting Started Manual (41 pages), Getting Started Manual (33 pages), Getting Started Manual (42 pages), Getting Started Manual (46 pages)

Print Page

Cisco TelePresence Video Systems



Introduction

On-screen menu for DX70 and DX80

When you start the system for the first time, the Setup assistant

starts automatically.

Read how to configure the system with the on-screen setup

assistant on page 20.

Settings menu

After the initial set up, you can revisit the configurations in the

Settings menu:

• Language: Select a language for the user interface.

• Time zone: Select your local time zone.

• Network connection: Change the IPv4 settings, if those

have not been configured by autoprovisioning or the

network. VLAN settings are also available.

• Service activation: Change provisioning settings, if those

have not been configured by autoprovisioning.

• Factory settings: Reset your video system to its factory

settings, and you lose your current registration. You cannot

undo a factory reset.

• Extended logging: Helps diagnose network issues and

problems during call setup. While in this mode more infor-

mation is stored in the log files. Extended logging uses

more of the system's resources, and may cause it to

underperform. Only use extended logging mode when you

are troubleshooting an issue.

D15318.03 Video Systems Getting Started Guide CE8.2, JUNE 2016.

User interfaces

Web interface

Setup assistant

• Do not disturb

• Screen brightness

• System Information

• Standby

To access the Settings menu, navigate to

upper left corner of the screen and press

on the remote control. Then navigate down

to System Information and press

again.

The System Information menu shows the

basic system information and potential

issues the system might have. You can also

restart the system from this page.

In addition this page provides access to

the Settings menu. These settings can

be protected with a PIN set from the web

interface.

Touch

Place calls

Getting Started Guide

Appendices

Selfview