Cisco Profile Series Manual - Page 8

Browse online or download pdf Manual for Conference System Cisco Profile Series. Cisco Profile Series 16 pages. Jbod on the 12g sas modular raid controller
Also for Cisco Profile Series: Getting Started Manual (41 pages), User Manual (44 pages), User Manual (7 pages), Getting Started Manual (35 pages), Quick Reference Manual (2 pages), Installation Manual (44 pages), Configuration Manual (13 pages), Installation Sheet (2 pages), Installation Manual (2 pages), Quick Start Manual (4 pages), Quick Start Manual (4 pages), Installing Manual (16 pages), Getting Started Manual (32 pages), Getting Started Manual (42 pages), Getting Started Manual (46 pages)

Print Page

Configuring Switches

• LINK/ACT—(Green) Located on the left of each port. The LED lights steady when a link between the

• SFP+ (if present)—(Green) Located on the right of a 10G port. The LED lights steady when a connection

Configuring Switches

The switch can be accessed and managed by two different methods; over your IP network using the web-based

interface, or by using the switch's command-line interface through the console port. Using the console port

requires advanced user skills.

The following table shows the default settings used when configuring your switch for the first time.

Parameter

Username

Password

LAN IP

Configuring Your Switch Using the Web-based Interface

To access the switch with a web-based interface, you must know the IP address that the switch is using. The

switch uses the factory default IP address of 192.168.1.254, with a subnet of /24. When the switch is using

the factory default IP address, the System LED flashes continuously. When the switch is using a DHCP

server-assigned IP address or an administrator has configured a static IP address, the System LED is a steady

green (DHCP is enabled by default).

If you are managing the switch through a network connection and the switch IP address is changed, either by

a DHCP server or manually, your access to the switch will be lost. You must enter the new IP address that

the switch is using into your browser to use the web-based interface. If you are managing the switch through

a console port connection, the link is retained.

To configure the switch using the web-based interface:

Step 1

Power on the computer and your switch.

Get To Know Your Switch

For example, the flash duration on the mamber 3 will be ~ 2.5 seconds [(3 LED off *0.5 seconds)

+ (2 "interim LED on" *0.5 seconds) = ~ 2.5 seconds).

• The flash on all member units will occur simultaneously. This means that the 1st flash on all member

units will occur at the same time, the 2nd flash (for units 2 and up) at the same time.

• The 20 second interval will be counted from the occurrence of the 1st flash on all member units.

This will allow the next flash cycle to begin at the same time on all units.

• If a member unit is removed from the stack, its system LED will continue to flash according to

above definition.

The following are per port LEDs:

corresponding port and another device is detected, and flashes when the port is passing traffic.

is made through the shared port, and flashes when the port is passing traffic.

Default Value

cisco

192.168.1.254

Get To Know Your Switch