Cisco Quick Set C20 Getting Started Manual - Page 21

Browse online or download pdf Getting Started Manual for Conference System Cisco Quick Set C20. Cisco Quick Set C20 35 pages. Tc7.3, english, december 2015
Also for Cisco Quick Set C20: Getting Started Manual (41 pages), User Manual (44 pages), Getting Started Manual (42 pages), Quick Reference Manual (2 pages), Quick Reference Manual (2 pages), User Manual (25 pages), Troubleshooting Manual (37 pages), Installation Sheet (2 pages), Quick Reference Manual (2 pages), Quick Reference Manual (2 pages), Getting Started Manual (32 pages), User Manual (48 pages), Getting Started Manual (42 pages), Getting Started Manual (46 pages)

Print Page

Cisco TelePresence Systems

GettinG started Guide

Table of contents

Introduction

remote control and on-screen menu

Using the remote control and on-screen menu for system configuration

Waking up the system

If there is no menu on screen, press

Home

remote control to show the menu.

If the system does not show a menu on screen:

• Make sure the monitor is connected and has been

switched on.

• Make sure the remote control has the batteries installed.

• Make sure the system is switched on.

If the system has just been switched on, wait a few minutes

to allow the system to start up.

If there is still no menu on screen, make sure the monitor

cable is connected to the basic video output connector. If in

doubt, see the Installation guide for your product.

User interfaces

(

)

on the

Configuration

Appendices

Remote control and

on-screen menu