Cisco Quick Set C20 Getting Started Manual - Page 27

Browse online or download pdf Getting Started Manual for Conference System Cisco Quick Set C20. Cisco Quick Set C20 35 pages. Tc7.3, english, december 2015
Also for Cisco Quick Set C20: Getting Started Manual (41 pages), User Manual (44 pages), Getting Started Manual (42 pages), Quick Reference Manual (2 pages), Quick Reference Manual (2 pages), User Manual (25 pages), Troubleshooting Manual (37 pages), Installation Sheet (2 pages), Quick Reference Manual (2 pages), Quick Reference Manual (2 pages), Getting Started Manual (32 pages), User Manual (48 pages), Getting Started Manual (42 pages), Getting Started Manual (46 pages)

Print Page
Cisco Quick Set C20 Getting Started Manual
Cisco TelePresence Systems
GettinG started Guide
Table of contents
Introduction
Web interface
Configuring IP
Your video conference system supports both IP version 4
(IPv4) and IP version 6 (IPv6).
In both cases, the IP parameters can be assigned
automatically by the network, or you can set everything
manually.
If you want to set the parameters manually please
contact your network administrator to obtain the required
parameters.
If an IP address is already assigned to your system, you will
find the current IPv4 and/or IPv6 address on the System
Information page:
Go to the
Diagnostics
tab and select
The IP address of the codec is shown in the top section.
Save the new value when you change a setting
Click
ok
to save the change, or
cancel
saving.
D14639.04 Video Systems Getting Started Guide (TC4.2) | 2011 JULY | © 2011 Cisco Systems, Inc. All rights reserved.
User interfaces
1. Select IP version
Go to the
Configuration
Configuration.
Click on
Network 1
which IP version to use in the
2. Select automatic or manual IP assignment
For IPv4: Click on the
DHCP
or
Static
For IPv6: Open the
Assignment
down list.
System
Information.
IPStack
to leave without
IPv4
IPv6
Configuration
Configuration
Appendices
tab and select
Advanced
and then on the
IPStack
value. Select
IPStack
drop down list.
Assignment
value and select
in the drop down list.
IPv6
folder and click on the
value. Select
Autoconf
or
Static
in the drop
DHCP/Autoconf
The IP configuration is complete.
a. Select
On
or
Off
in the
DHCPOptions
down list according to your preference.
DHCP Options:
1
Off: All IP parameters, except the IP address and gateway, must be set manually.
Please refer to the Administrator Guide for your product for details about all settings.
On: The IP parameters, like the DNS and NTP server addresses, will be obtained automatically from the network.
3. Set the IP addresses
Set the remaining IP settings according to the table to
the right. The actions required depend on the IP version
(IPStack) and IP assignment method (Assignment) you
selected in the previous steps.
Assignment
Static
a. Open the
IPv4
folder; click on the Address,
SubnetMask
and
Gateway
the addresses in the corresponding input
fields.
b. Open the
DNS
folder, and then the
Server 1
folder; click on the
and enter the DNS server address in the
corresponding input field.
drop
a. Select
On
or
Off
in the
DHCPOptions
down list according to your preference.
1
b. Click on the
Address
and
to enter the system IP address and the
gateway address in the corresponding input
fields.
27
values and enter
Address
value
drop
1
Gateway
values
www.cisco.com