Cisco SX series Getting Started Manual - Page 18

Browse online or download pdf Getting Started Manual for Conference System Cisco SX series. Cisco SX series 34 pages. Telepresence video systems
Also for Cisco SX series: Getting Started Manual (33 pages), Getting Started Manual (46 pages)

Print Page

Cisco TelePresence Video Systems



Introduction

Date, time and location

(When not set by a provisioning system)

We recommend you check that the date and time settings

are correct when you set up your video conference system.

The system uses this information for example to time stamp

messages transmitted to gatekeepers and other network

elements.

If you are changing a value setting,

you have to always click

save

to confirm the change.

D15318.03 Video Systems Getting Started Guide CE8.2, JUNE 2016.

User interfaces

Web interface

1. Go to

Setup

settings from the left column.

2. Select your preferred date format, time format, and your

time zone in the corresponding drop down lists.

3. Open the

4. Under the

Mode

drop down list.*

a. If you select

the

Address

b. If you select Off, you have to enter the time and date

manually using either the Touch controller (

> Administrator > Date, Time &

command line interface (xCommand Time DateTime

Set) .

5. To verify the time settings, go to

Open

Time

* NTP mode:

Auto: The time is regularly updated using an NTP server. The NTP server

address is automatically obtained from the network (DHCP).

Manual: The time is regularly updated using an NTP server. You must

manually enter the NTP server address.

Off: You must set the time manually. The time is not updated automatically.

Setup assistant

tab and select Configuration. Open the

NetworkServices

settings from the left side bar.

NTP

section select Auto,

Manual

Off

Manual,

enter the NTP server address in

input field.

Settings

Location) or on the

Setup

and click Status.

status from the left side bar.

Touch

Time

in the

Getting Started Guide

Appendices