Cisco SX series Getting Started Manual - Page 29

Browse online or download pdf Getting Started Manual for Conference System Cisco SX series. Cisco SX series 34 pages. Telepresence video systems
Also for Cisco SX series: Getting Started Manual (33 pages), Getting Started Manual (46 pages)

Print Page

Cisco TelePresence Video Systems



Introduction

Configure H.323 and SIP

(When not set by a provisioning system)

To get online and ready to place and receive calls, your

system must be set up properly. Your system uses either the

H.323 protocol or the SIP protocol for video calls.

NOTE:

Contact your system administrator, or service provider,

for information about the network settings.

For networks administered through Cisco TMS (TelePresence

Management Suite), your Cisco TMS administrator will help

you to get online.

You can find information about administering through Cisco

UCM in the

Administering CE endpoints on CUCM

D15318.03 Video Systems Getting Started Guide CE8.2, JUNE 2016.

User interfaces

Web interface

H.323

If in doubt about any of the parameters below, contact your

system administrator or your service provider.

1. Tap the gearwheel icon in the upper left corner and tap

Settings > Administrator >

2. Enter the

input fields.

3. Enter the

field.

guide.

4. If the H.323 gatekeeper requires authentication and you

want your system to authenticate itself to the gatekeeper,

tap

Otherwise, tap OFF.

5. Tap

Save

without saving.

6. Review the System Information page and verify the H323

settings.

If you have successfully registered to the Gatekeeper,

the

Status

7. Tap

Exit

Setup assistant

H323.

H323 Number

and

H323 Id

in their respective

Gatekeeper Address

in the corresponding input

in the

Authentication Mode

section and enter the

and

Password

in their respective input fields.

to confirm the changes, or

Undo

to leave

is shown as

Registered

in the H323 section.

to return to the home menu.

Getting Started Guide

Touch

Appendices

SIP

If in doubt about any of the parameters below, contact your

system administrator or your service provider.

1. Tap the gearwheel icon in the upper left corner and tap

Settings > Administrator >

SIP.

2. Enter the SIP URI in the

URI

input field.

3. Tap the preferred transport protocol in the

Transport

section. If you select Auto, the system tries

first to connect using TLS, then TCP, and finally UDP.

4. Select a

Proxy Type

by tapping

or +. The default type is

Standard. You can use

Cisco

when registering to CUCM.

5. Enter the

Proxy Address

in the corresponding input field.

6. If the SIP proxy server requires authentication, you must

enter the

and