Cisco SX80 Installation Manual - Page 3

Browse online or download pdf Installation Manual for Conference System Cisco SX80. Cisco SX80 7 pages. With touchpad 10
Also for Cisco SX80: Installation Manual (7 pages), Quick Reference Manual (2 pages), Manual (45 pages), Manual (45 pages), User Manual (19 pages), Installation Manual (24 pages), Installation Manual (2 pages), Quick Reference Manual (2 pages), Quick Reference Manual (2 pages), Reference Manual (8 pages), Getting Started Manual (46 pages)

Print Page

Installation guide for Cisco TelePresence SX80

Connect to LAN, microphones, loudspeakers, Touch 10, cameras and screens

Make sure all units are switched off when connecting or disconnecting cables.

LAN (RJ-45)

Always use the

Ethernet port

for LAN.

4 × programmable

GPIO pins

(Euroblock,

2 × USB

SWITCH

PoE

injector

Touch 10 control panel (RJ-45)

Insert the provided PoE injector

between Touch 10 and the codec's

or 3

Ethernet port

About the 2

and 3

Ethernet port

The codec's 2

and 3

Ethernet ports should be used for the Touch 10 control panel,

as well as for the Cisco's SpeakerTrack 60, Precision 60, and Quad cameras.

Connect a network switch to the codec's 2

two ports to support your devices.

Microphones, max 8 (Euroblock, 3.5 mm)

If your microphone cable has 3 pins,

use ,

mute pin ( ) unused.

3.5 mm)

10 Gb Ethernet

Power

(100-240 VAC,

To camera control

50/60 Hz)

Cameras (HDMI)

How to connect cameras are described

overleaf. Note that different cameras use

different ports for camera control.

or 3

Ethernet port, if you need more than

and ground ( ) and leave the

2 × stereo audio line in,

e.g. from PC

(Euroblock, 3.5 mm)

Video input,

Analog video input:

e.g. from PC

Composite, Y;

(DVI-I)

S-video, Y and C

(BNC)

The audio line outputs may be configured to be used for loudspeakers.

The Ethernet connector is at the rear of Touch 10. The Ethernet cable between Touch 10 and the PoE

injector must be PoE rated (provided). The Ethernet cable between the PoE injector and the codec is not

required to be PoE rated (not provided).

There is no DC power output from the camera control port. Use an external power supply for the camera.

Loudspeakers, mono or stereo (Euroblock, 3.5 mm)

Use speakers with amplifiers. The speaker/amplifier

should have balanced input to avoid ground loop noise.

2 × stereo audio line out,

e.g. to recorder

(Euroblock, 3.5 mm)

Camera control for the

Precision 40 / PrecisionHD

1080p 4xS2 camera

Screens, max 3

(2 HDMI, 1 DVI-I)

Serial port

Ground

(D-SUB 9)

(Protective earth)

Power

(D-SUB 9)