Cisco TelePresence ISDN Link Administrator's Manual - Page 17

Browse online or download pdf Administrator's Manual for Conference System Cisco TelePresence ISDN Link. Cisco TelePresence ISDN Link 27 pages. Isdn link

Print Page

Cisco TelePresence ISDN Link

Contents

Introduction

Example with ISDN BRI Euro type

In this example the ISDN type is BRI and European type, the number is 8001-8004, and the

endpoint is connected directly to the ISDN Link. There is no IP infrastructure and the endpoint must

not be registered to VCS when using this configuration.

Endpoint configuration

Use the Remote Control or Touch panel to configure.

Network 1 > Assignment = Manual

Network 1 > IPv4 > Address = 192.168.1.100

Network 1 > IPv4 > SubnetMask = 255.255.255.0

Network 1 > IPv4 > Gateway = 192.168.1.1

Conference 1 > DefaultCall > Protocol = SIP

Conference 1 > DefaultCall > Rate: 512 (Euro BRI 4 channels @ 128 kbps)

ISDN Link configuration

Use the serial port to configure.

xConfiguration Network 1 Assignment: Static

(Set Static IP)

xConfiguration Network 1 IPv4 Address: "192.168.1.101"

(Set the IP address of the ISDN Link)

xConfiguration Network 1 IPv4 SubnetMask: "255.255.255.0"

(Set the subnet mask of the ISDN Link)

xConfiguration Gateway SIP PeerHost: "192.168.1.100"

(Set the IP address of the endpoint)

xConfiguration H320 NetType: BRI

(Set type of ISDN)

xConfiguration ISDN BRI SwitchType: Euro

(Set the ISDN switch type; must match switch type in Adtran)

xConfiguration ISDN BRI Interface 1 Mode: On

xConfiguration ISDN BRI Interface 2 Mode: On

xConfiguration ISDN BRI Interface 3 Mode: On

xConfiguration ISDN BRI Interface 4 Mode: On

(Enable the BRI interfaces)

xConfiguration ISDN BRI Interface 1 DirectoryNumber 1 Number: "8001"

xConfiguration ISDN BRI Interface 2 DirectoryNumber 1 Number: "8002"

xConfiguration ISDN BRI Interface 3 DirectoryNumber 1 Number: "8003"

xConfiguration ISDN BRI Interface 4 DirectoryNumber 1 Number: "8004"

(Enter your BRI numbers, this MUST be according to the ISDN network configuration.)

D14954.01

ISDN Link Administrator Guide IL1.0, June 2012.

Getting started

Configuration examples

ISDN only

Dialling from the endpoint

From the endpoint you should now be able to dial an ISDN number using the following format:

Format: <ip address>;x-h320number=XXXX

• Where XXXX is the ISDN number you wish to call.

• In this case, with no IP infrastructure, we use the IP Address to identify the ISDN Link.

Example: 192.168.1.101;x-h320number=1234

Password protection

Appendices

EX90

ISDN Network

ISDN Link

Administrator guide