Cisco TelePresence IX5000 First-Time Setup - Page 6
Browse online or download pdf First-Time Setup for Conference System Cisco TelePresence IX5000. Cisco TelePresence IX5000 40 pages. Field-replaceable units and countryand region-specific power connectors
Also for Cisco TelePresence IX5000: Quick Start User Manual (15 pages), User Manual (26 pages), Installation Manual (36 pages), Manual (44 pages)
Print Page
Configuring Cisco Unified Communications Manager for Your Cisco TelePresence System
Tip
For an IX5200, configure the device type as Cisco TelePresence IX5000 (18 seats).
Load the Cisco TelePresence Administration Software image on the Unified CM server.
Step 2
If your Unified CM has already loaded the required IX5000 software, you can skip this step.
Note
Step 3
Add your system as a device in Unified CM. For more information, refer to the
to Unified CM"
document.
Add the TFTP server(s) used by the Unified CM server to your system using the IX System
Step 4
administration GUI. Complete the following steps:
a.
b.
c.
d.
e.
For more information about configuring Unified CM with your Cisco TelePresence device, refer to the
Configuring Cisco Unified Communications Manager for the IX System
Finding the MAC Address for Your System
You need the codec MAC address to configure your system in Unified CM. There are two MAC
addresses on the codec. Use the address that is nearest the Uplink and EX1 Ethernet connections.
Figure 1
You can also find this address on the blue screen while your system is booting up.
Tip
Cisco TelePresence IX5000 and IX5200 First-Time Setup
6
section in the
Log into the IX System administration GUI for your system as user admin. The default password is
cisco.
Click the Configuration icon (the gear on the left of the screen).
Scroll down to the Call Control Manager section.
Enter the TFTP Server(s) in the Call Control Manager area.
Click Apply.
provides an example.
Configuring Cisco Unified Communications Manager for the IX System
"Adding an IX System
document.
OL-27038-01