DigiTech BP355 Quick Start Manual

Browse online or download pdf Quick Start Manual for Recording Equipment DigiTech BP355. DigiTech BP355 2 pages.

Print Page

WHAT'S IN THE BOX

BP355 Bass Multi-Effects Processor & USB Recording Interface

•

Power Supply

GET X-EDIT

To get the X-Edit software, visit

http://digitech.com/en-US/products/bp355#downloads.

To activate your warranty, please register at

http://digitech.com/en-US/support/warranty_registration.

GET THE OWNER'S MANUAL

Scan the QR code to get the owner's manual or visit

http://digitech.com/en-US/products/bp355#documentation.

MAKING CONNECTIONS / APPLYING POWER

A. Set your bass amp(s) to a clean tone, set

the tone controls for a flat EQ response

(on most amps, this would be 0 or 5

Live Application

on the tone controls), turn the volume

control(s) all the way down, then power

off the amp(s). If connecting to a mixer,

fully lower the corresponding channel

fader(s).

B. Make connections as shown in the

diagrams to the right, depending on

application type.

C. Connect the included power supply to

the POWER input jack and plug it into

an available AC outlet.

D. Set the BP355's MASTER LEVEL control

to 75.

E. Power on your bass amp(s). slowly

raise the amp volume control(s) for the

desired volume. If using a mixer, adjust

each channel's gain/trim and fader

controls for the desired volume.

A. To bypass effects, press the UP and DOWN

footswitches simultaneously. The display

Recording / Practice Application

will read "BYPASS".

B. To exit Bypass mode, press any footswitch.

C. To use the Tuner, press and hold the UP

and DOWN footswitches simultaneously

for 2 seconds. The display will briefly read

"TUNER" then enter Tuner mode.

D. Play a note on the bass. The note will be

shown in the display and the LEDs on the

left will indicate if the note is sharp, flat, or

in tune.

E. To exit Tuner mode, press any footswitch.

BYPASSING EFFECTS & USING THE TUNER

Sharp

In Tune

Flat

Press for Bypass, hold for Tuner