Cisco TelePresence MX300G2 Manual - Page 12

Browse online or download pdf Manual for Conference System Cisco TelePresence MX300G2. Cisco TelePresence MX300G2 45 pages. In-room control on touch 10
Also for Cisco TelePresence MX300G2: Manual (45 pages)

Print Page

Apply the in-room control panel to the video system

Table of contents

(Not available when using the offline editor. Instead, you should export the in-

room control panel to a file in order to save your work for later.)

Introduction

Apply the in-room control panel to the video system. You will see the results

immediately on the Touch 10.

• Choose

Create a user interface

API for in-room control

Check the result on Touch 10

(Not available when using the offline editor.)

Widgets

Tap the in-room control icon (light bulb or generic utility icon) in the Touch 10

status bar to open the in-room control panel.

Command reference

Troubleshooting

Tips and tricks

Examples

Which in-room control icon to display is defined under

you change to the other icon, you have to export the in-room control panel to

the video system again.

D15358.01 APRIL 2016

Collaboration Endpoint software

version 8.1

Export > To codec

Export the in-room control panel to file

Export the in-room control panel to a file, which can be imported back into the

editor at a later stage.

• Choose

If you are using the offline editor, this is the only way you can save your work for

later.

Exporting to file may also be useful as a way of creating a design template if you

are going to push the same in-room control panel to multiple video systems.

Files exported while connected to a video system are in the same format as

files exported from an offline editor. This means that any of these files can be

imported into an editor launched from a video system's web interface, and then

pushed to the video system's Touch 10.

In-room control icon

Settings

in the editor. If

Export > To file