Cisco TelePresence SX20 User Manual

Browse online or download pdf User Manual for Conference System Cisco TelePresence SX20. Cisco TelePresence SX20 5 pages. In-room control on touch 10
Also for Cisco TelePresence SX20: Quick Set (8 pages), Getting Started Manual (41 pages), Getting Started Manual (42 pages), Quick Reference Manual (2 pages), Quick Set (2 pages), Quick Reference Manual (2 pages), User Manual (34 pages), User Manual (29 pages), Troubleshooting Manual (37 pages), Regulatory Compliance And Safety Information Manual (9 pages), Setup Manual (8 pages), User Manual (38 pages), Installation Manual (2 pages), User Manual (2 pages), Quick Reference Manual (2 pages), User Manual (37 pages), Manual (45 pages), Manual (45 pages), Installation Sheet (2 pages), Installation Manual (2 pages), User Manual (34 pages), User Manual (38 pages), User Manual (38 pages), Getting Started Manual (42 pages), Reference Manual (8 pages), Getting Started Manual (46 pages)

Print Page

User

Guide

Turning On/Waking up the Telehealth System

To turn on the system, press the

Ensure Cisco system white light is on.

To wake up the Telehealth system, press any button on the remote.

If the systems does not turn on/wake, ensure the TV is on the

appropriate input.

If you see the system name appear at the top of the screen the system is

online.

If you see

'No Network Connection'

is offline. Please contact your regional technical support to resolve any

connectivity issues.

The Remote

1. Decrease/Increase volume.

2. Parameter keys which move the cursor

left/right/up/down.

3. OK/Enter.

4. Go back one step.

5. Microphone mute/unmute.

6. Go back/Call button/Accept incoming call.

7. Reject incoming call/End call/Cancel/Go back

to Home screen.

8. Keypad: used to dial.

The Home Screen

1. The

'Settings'

icon provides access to Standby mode,

System Information and the Do Not Disturb feature. When

set to

'Do Not Disturb,'

ringtones and call attempts made

by others to reach you will appear as missed calls. You

may, however, place a call. While in

system will return to normal operation after 60 minutes.

2. The

'Call'

icon is located to the left in the lower part of

the display.

3. The

'Share Content'

icon is located to the right in the

lower part of the display.

4. The

'Camera Control'

corner of the display.

Receiving a Call

If someone calls you, you may accept or decline the call. If you

decline the call, a message stating that the unit is busy will be

sent to the caller. You may also use the call keys located

below the circular buttons on the remote control to

accept/decline a call (green=accept, red=decline).

Cisco SX10, SX20

'Power'

button on the remote control.

at the top of the screen the system

'Do Not Disturb,'

menu is located in the upper right

the

August 2019