Cisco 1230AG - Aironet - Wireless Access Point Configuration Manual - Page 24

Browse online or download pdf Configuration Manual for Network Hardware Cisco 1230AG - Aironet - Wireless Access Point. Cisco 1230AG - Aironet - Wireless Access Point 40 pages. Wlc (wireless lan controller), wism (wireless services module) integrated wlc with aps

Print Page

Configuring a New Controller Starting from Factory Defaults

Connecting to the Controller Via a Browser

1. Initial provisioning of the controller is done via the command line

interface (CLI). Connect a null modem serial cable between the

console port of the controller and the serial port of a PC.

2. Open a terminal program, such as Hyper Terminal, and configure the

port settings to 9600 baud, no parity, 8 data bits and 1 stop bit.

3. Power-on the controller. Status of the controller's boot process will

appear as the controller is powering up. Once the controller is

running, it will prompt you to run the Startup Wizard.

4. The Startup Wizard provides for an easy means to perform initial

controller setup and provisioning. Refer to the Installation and Startup

Guide for the Cisco 4400 Series WLC, or other appropriate controller,

found at Cisco's website. This document contains a detailed

explanation of using the Startup Wizard for the 4400:

http://www.cisco.com/en/US/docs/wireless/controller/4400/quic

k/guide/ctrlv32.html#wp34023

5. Once the controller has been configured via the Startup Wizard, the

remaining configuration can be configured through the switch-web

interface using a Web browser (Cisco recommends using MS IE 6.0+).

6. If necessary, the controller can be reset to factory defaults. To reset

the WLC to factory default, you must reboot, then type

at the CLI. This only works before the first time a user logs in

config

via the console.

1. Connect to the WLC by pointing your internet browser to the URL:

https<IP_Addr> (where <IP_Addr> is the IP address of the

management interface of the WLC).

2. Click the

prompt. The default

admin

3. Once logged in properly, a page similar to the one below displays.

VIEW Certified Configuration Guide

Recover-

and

User Name

Password

PN: 1725-36192-001_H