Cisco 2600 Series Installation Manual - Page 9

Browse online or download pdf Installation Manual for Network Hardware Cisco 2600 Series. Cisco 2600 Series 12 pages. Configuring adsl wic to support pppoe clients
Also for Cisco 2600 Series: Release Notes (32 pages), Configuration (15 pages), Application Note (41 pages), Datasheet (6 pages), Appendix (15 pages), Installation Manual (22 pages), Overview (13 pages), Quick Start Manual (2 pages), Manual (5 pages)

Print Page

Align the Cisco RPS Adapter Plate with the chassis cutout for the power supply. Tilt the

Step 3

adapter plate slightly toward you at the top, and rock it up and into place, ensuring that

the two small hooks at the top of the Adapter Plate engage the router chassis. (See

Figure 9.)

Figure 9

Installing the Cisco RPS Adapter Plate

Install the mounting screw that came with the Cisco RPS Adapter Plate into the screw

Step 4

hole. (See Figure 10.)

Figure 10

Installing the Mounting Screw

DC INPUT FOR USE WITH CISCO RPS

+5V– – –10A, +12V– – –2A, -12V– – –1A

Mounting

screw

Connect the six-pin connector to the system board. The connector is keyed so that it

Step 5

cannot be connected to the system board incorrectly. (See Figure 11.)

Step 6

Connect the 4-pin environmental status connector only if your router, with the connector

connected, has been upgraded to the correct level of Cisco IOS software. Using any other

level of Cisco IOS software can cause the router to crash. Cisco IOS Release 11.1(12)AA

or later is compatible but will not show status from the RPS. Cisco IOS Release 11.2(7)P

or later will provide RPS status information to the network.

Installing the Redundant Power Supply Adapter Plate

Installing the Cisco RPS Adapter Plate in Cisco 2600 Series Routers

Front of chassis