Argo SDIBS9DC Operating Instructions Manual - Page 4

Browse online or download pdf Operating Instructions Manual for Air Conditioner Argo SDIBS9DC. Argo SDIBS9DC 15 pages. Split air conditioner system
Also for Argo SDIBS9DC: Installation Instructions Manual (19 pages), Operating Instructions Manual (17 pages)

Print Page

InStALLAtIon LoCAtIon

We recommend this air conditioner to be installed

properly by qualified installation technicians in

accordance with the installation instructions

provided with the unit.

WARnInG

Do not install this air conditioner where there are

fumes or flammable gases, or in an extremely humid

space such as a green house.

Do not install the air conditioner where excessively

high heat-generating objects are placed.

Do not install the air conditioner where the

atmosphere is extremely damp or humid (e.g.

greenhouse or laundry) it could be wetted by drops

of water (i.e. in laundries).

to protect the air conditioner from heavy corrosion,

avoid installing the outdoor unit where salty sea

water can splash directly onto it or in sulphurous

air near a spa.

ELEtRICAL REQUIREMEntS

Before installation, check that the voltage of the electric

supply in your home or office is the same as the voltage

shown on the nameplate.

All wiring must conform to the local electrical codes.

Consult your dealer or a qualified electrician for details.

Each unit must be properly grounded with a ground (or

earth) wire or through the supply wiring.

Wiring must be done by a qualified electrician.

SAFEtY InStRUCtIonS

Read this booklet carefully before using this air

conditioner. If you still have any difficulties or

problems, consult your dealer for help.

this air conditioner is designed to give you

comfortable room conditions. Use this only for its

intended purpose as described in this Instruction

Manual.

WARnInG

Never use or store gasoline or other flammable vapor or

liquid near the air conditioner. It is very dangerous.

never install electrical equipment, which is not

protected with IPX1 protection (protection against

vertical water drop), under the unit.

The manufacturer assumes no responsabilities if the

safety regulations or local codes are not observed.

CAUtIon

never use the power main switch to start or stop the

air conditioner: always use the on/oFF button on the

remote control unit or the selector switch on the unit.

Do not let children play with the air conditioner.

Do not cool the room too much if babies or invalids

are present.

this air conditioner is not intended for use by persons

(including children) with reduced physical, sensory

or mental capabilities, or lack of experience and

knowledge, unless they have been given supervision

or instruction concerning use of the air conditioner

by a person responsible for their safety.

USInG thE REMotE ContRoL UnIt

hoW to InStALL BAttERIES

Remove trhe lid in the rear part of the remote control

unit and check the settings of the four microswitches

as shown below:

SWITCHES

Insert two AAA alkaline batteries of 1,5 V-DC making

sure that point in the direction marked in the battery

compartment.The displayed time flashes.

Press the SEL TYPE button.

Remote controller is now ready for operation.

The batteries last average more than six months,

anyway it depends on how much you use the remote

control unit.

Remove the batteries if you do not use the remote

control unit for more than one month.

Replace the batteries when the remote control unit

lamp fails to light, or when the air conditioner does not

receive the remote control unit signals.

The batteries of the remote control contain polluted

substances. Exhausted batteries must be disposed

according to the laws in force.

IF YoU InStALL MoRE thAn onE InDooR

notE

UnIt In thE SAME RooM:

It is possible to utilise only one remote control for all

the units.

on the contrary, if you want to address each remote

control to its unit, follow the procedure"Remote control

unit/indoor unit address" (see Installation Instructions).

tEMPERAtURE SEnSoR SELECtoR

Under normal conditions the room temperature is

detected and checked by the temperature sensor placed

in the remote controller (I FEEL icon displayed ).This

function is designed to provide a comfortable room

temperature by transmitting the temperature control

command from the location next to you. When using this

function, the remote, control should always be pointed

at the air conditioner, therefore it should be placed in

a position in which it is visible by the indoor unit (for

example, do not put it in a drawer).

It is possible to disable the remote controller room

sensor pressing the I FEEL button. In this case the I

FEEL icon on the remote controller display lights off and

only the sensor placed in the air conditioner becomes

active.

notE

the remote control unit transmits signals to the

indoor unit each time you press a key and at any

temperature change detected by the IFEEL sensor. In

case of troubles (low batteries, remote control placed

in a position not visible by the indoor unit,...) room

temperature control is automatically switched to the

sensor of the indoor unit. In this case, the temperature

around the remote control unit may differ from the

temperature detected in the air conditioner position.

oPERAtIon WIth thE REMotE ContRoL UnIt

When using the remote control unit, always point the unit

transmitter head directly at the air conditioner receiver.

hoW to tURn on thE AIR ConDItIonER

Press the ON/OFF button to turn the air conditioner on.

The operation lamp will light up, indicating the unit is in

operation.

PLEASE, SEE thE EnD

oF thIS MAnUAL FoR

DEtAILS