Argo THOR Operating Instructions Manual - Page 14

Browse online or download pdf Operating Instructions Manual for Air Conditioner Argo THOR. Argo THOR 20 pages.

Print Page

WARNING!

Before carrying out any cleaning or maintenance operations, unplug the appliance.

1. Cleaning the air filter

The air filter must be checked at least once every two weeks of operation.

Operation with a dirty or clogged filter always causes a reduction in the

efficiency of the air conditioner and can cause serious problems. To remove

the filter, unhook the rear grille (Fig.1) and then remove the filter, gently

pulling it upwards (Fig.2). Use a vacuum cleaner to remove dust. If this is

not enough, wash the filter with warm water and possibly neutral detergent,

rinse it with cold water and let it dry naturally before putting it back in its

place. Once the filter has been reinserted, close the grille and resume use

of the air conditioner.

The lower air filter is screwed on and therefore cannot be removed

2. Cleaning of casing

Use a damp and soft cloth to clean the outer surface of the appliance. Do not use excessively hot water, solvents,

petrol or other aggressive chemical compounds, talcum powder or brushes: these may damage the surface or

colour of the casing. Remove any stains using lukewarm water with a little neutral detergent. Do not pour water

onto the air conditioner to clean it, as this may damage its internal components or cause a short-circuit.

3. Storage

When the air conditioner is not expected to be used for a long time, clean the filters before storing it away. Keep

the appliance in a vertical position at all times. Do not place heavy objects on top of the air conditioner. It is

advisable to protect the appliance with a plastic sheet.

4. Transport

Transport the air conditioner in the vertical position. Should this not be

possible, rest it on its right-hand side; when the appliance reaches its final

destination, place it immediately in the vertical position and wait at least 4

hours before operating it in cooling mode.

5. For complete safety, regularly check the condition of the power cord; should it be damaged as a result of wear,

contact the Service Centre to replace it.

V 04/23

CARE AND MAINTENANCE