Cisco 2691 Series Quick Start Manual - Page 20

Browse online or download pdf Quick Start Manual for Network Hardware Cisco 2691 Series. Cisco 2691 Series 29 pages. Modular routers
Also for Cisco 2691 Series: Installing And Formatting (34 pages), Datasheet (8 pages), User Manual (48 pages)

Print Page

Enter a host name for the router (this example uses 2691):

Step 3

Configuring global parameters:

Enter host name [Router]: 2691

Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when viewing the

Step 4

configuration:

The enable secret is a password used to protect access to

privileged EXEC and configuration modes. This password, after

entered, becomes encrypted in the configuration.

Enter enable secret: xxxxxx

Enter an enable password that is different from the enable secret password. This password is not encrypted (less secure)

Step 5

and can be seen when viewing the configuration:

The enable password is used when you do not specify an

enable secret password, with some older software versions, and

some boot images.

Enter enable password: xxxxxx

Step 6

Enter the virtual terminal password, which prevents unauthenticated access to the router through ports other than the

console port:

The virtual terminal password is used to protect

access to the router over a network interface.

Enter virtual terminal password: xxxxxx

Step 7

Respond to the following prompts as appropriate for your network:

Configure SNMP Network Management? [yes]:

Community string [public]:

Step 8

A summary of the available interfaces is displayed:

Note

The interface numbering that appears is dependent on the type of Cisco modular router platform and on the

installed interface modules and cards.

Current interface summary

Controller Timeslots D-Channel Configurable modes Status

T1 0/0

Any interface listed with OK? value "NO" does not have a valid configuration

Interface

FastEthernet0/0

FastEthernet0/1

Select one of the available interfaces for connecting the router to the management network:

Step 9

Enter interface name used to connect to the

management network from the above interface summary: fastethernet0/0

Step 10 Respond to the following prompts as appropriate for your network:

Configuring interface FastEthernet0/0:

Use the 100 Base-TX (RJ-45) connector? [yes]: yes

Operate in full-duplex mode? [no]: no

Configure IP on this interface? [yes]: yes

IP address for this interface: 172.1.2.3

Subnet mask for this interface [255.255.0.0] : 255.255.0.0

Class B network is 172.1.0.0, 16 subnet bits; mask is /16

pri/channelized

IP-Address

OK? Method Status

unassigned

Administratively up

unset

Prol

dow