Cisco 3110 Manual - Page 15

Browse online or download pdf Manual for Network Hardware Cisco 3110. Cisco 3110 42 pages.
Also for Cisco 3110: Getting Started (42 pages)

Print Page

Overview

Caution

Note

For More Information

• See

8-Port 1/10/25-Gb Network Module

The Secure Firewall 3100 chassis has one network module slot named NM-2. Network modules are optional,

removable I/O modules that provide either additional ports or different interface types. The network module

plugs into the chassis on the front panel. See

slot on the chassis.

FPR-X-NM-8X10G supports 1 Gb and 10 Gb full-duplex Ethernet traffic per port and is supported on all

Secure Firewall 3100s. FPR-X-NM-8X25G supports 1 Gb, 10 Gb, or 25 Gb full-duplex Ethernet traffic per

port and is supported only on the 3130 and 3140.

The top ports are numbered from left to right—Ethernet 2/1, Ethernet 2/3, Ethernet 2/5, and Ethernet 2/7. The

bottom ports are numbered from left to right—Ethernet 2/2, Ethernet 2/4, Ethernet 2/6, and Ethernet 2/8 (see

the figure below). Up arrows are the top ports and down arrows are the bottom ports (see the figure below).

This network module supports SFP/SFP+/SFP28 transceivers. See

, on page 29

Note

The following figure shows the front panel of the 1/10-Gb and 1/10/25-Gb network module.

If you remove the system power cords before the graceful shutdown is complete, disk corruption can

occur. You can move the power switch to OFF before the shutdown. The system ignores it.

After removing power from the chassis by unplugging the power cord, wait at least 10 seconds before

turning power back ON. You want to keep the system power off, including the standby power, for 10

seconds.

Remove and Replace the Power Supply Module

power supply module in the Secure Firewall 3100.

Remove and Replace the Dual Fan Module

fan module in the Secure Firewall 3100.

Ground the Chassis

for the procedure for using the grounding lug to ground the chassis.

Power Supply Module, on page 24

Dual Fan Modules, on page 26

for the list of Cisco-supported transceivers.

The hardware and the system support hot swapping if you are replacing a network module with the same type

of network module. You must first disable the network port and then reenable it after replacement. If you

replace the 8-port 1/10/25-Gb network module with another supported network module, you must reboot the

chassis so that the new network module is recognized. See the configuration guide for your operating system

for the detailed procedures for managing network modules.

for the procedure for removing and replacing the

for the procedure for removing and replacing the dual

for a description of the power supply module LEDs.

for a description of the fan LEDs.

Front Panel, on page 8

for the location of the network module

Supported SFP/SFP+/QSFP+ Transceivers

8-Port 1/10/25-Gb Network Module

Overview