Cisco 5400 Installing And Upgrading - Page 3

Browse online or download pdf Installing And Upgrading for Network Hardware Cisco 5400. Cisco 5400 8 pages. Frus
Also for Cisco 5400: Preparing For Installation (6 pages)

Print Page

Installing and Upgrading FRUs

2. Press the push button on the center of the cover and pull the cover out of the system to expose the slot.

3. Slide the drive into the slot.

Note

Keep the drive bays covered when there are no drives installed in the slot.

Figure 3: Covers of Hard Disk Drive Slots

Upgrading the M.2 Storage Module

The M.2 storage module is a hardware that is 22mm wide and 80mm long. This hardware comes with different

storage capacities.

These are the steps to upgrade the M.2 memory module:

1. Remove the chassis cover.

2. Locate the M.2 storage module. Refer to the

module.

3. Remove the old storage module by unscrewing the screw that secures the hardware and removing out the

storage module.

4. Plug in the new storage module in the same location and secure it with the screw.

Upgrading the M.2 Storage Module

Chassis - Internal View

section to identify and locate the

Installing and Upgrading FRUs