Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Installation Note - Page 10

Browse online or download pdf Installation Note for Network Hardware Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 18 pages. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Also for Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Installation Note (14 pages), Solution Manual (17 pages), Installation Note (46 pages), White Paper (19 pages), Description (1 pages), Product Bulletin (6 pages), Notice (4 pages), Datasheet (9 pages), Datasheet (18 pages), White Paper (18 pages), Configuration Manual (8 pages), Installation Note (28 pages), Troubleshooting Manual (11 pages), User Manual (17 pages), Installation Note (24 pages), Manual (19 pages), Installation Note (36 pages)

Print Page

Installing the MSFC2

Figure 7

Ensure that the connectors on the MSFC2 (see

Step 2

supervisor engine.

Figure 8

Edge connector

Carefully seat the MSFC2 onto the supervisor engine. (See

Step 3

November 2001 or

Step 4

Using your thumbs, apply pressure at the connector locations (shown in

before November 2001 or

MSFC2 is securely seated on the supervisor engine.

Catalyst 6500 Series Supervisor Engine 1A DRAM Upgrade Installation Note

Male Standoff Location on the Supervisor Engine

WS-X5530

SWITCH LOAD

100%

SUPERVISOR ENGINE I I I

CONSOLE

MSFC2 Connectors

Figure 10

for an MSFC2 shipped after November 2001.)

Figure 10

Male standoff

Figure

8) are aligned with the connectors on the

6-pin connector

Figure 9

for an MSFC2 shipped after November 2001) to ensure that the

for an MSFC2 shipped before

Figure 9

for an MSFC2 shipped

78-14357-02