Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Manual - Page 13

Browse online or download pdf Manual for Network Hardware Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 19 pages. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Also for Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Installation Note (14 pages), Solution Manual (17 pages), Installation Note (46 pages), White Paper (19 pages), Description (1 pages), Product Bulletin (6 pages), Notice (4 pages), Datasheet (9 pages), Datasheet (18 pages), White Paper (18 pages), Configuration Manual (8 pages), Installation Note (28 pages), Troubleshooting Manual (11 pages), Installation Note (18 pages), User Manual (17 pages), Installation Note (24 pages), Installation Note (36 pages)

Print Page
Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Manual
Cisco - Connecting a Terminal to the Console Port on Catalyst Switches
Switch
RJ45-to-RJ45
Console
Rollover Cable
(DTE)
RJ45
Signal
Pin
RTS
1¹
DTR
2
TxD
3
GND
4
GND
5
TxD
6
DSR
7
CTS
8¹
¹Pin 1 is connected internally to Pin 8.

Configuring a Terminal for Attachment to the Console or RSFC Port

Note: The console port is an asynchronous (Async) serial port; any device connected to this port must be
capable of asynchronous transmission.
Before connecting the console port, check the terminal documentation to determine the baud rate. The
baud rate of the terminal must match the default baud rate (9600 baud) of the console port. Set up the
terminal as follows:
9600 baud
8 data bits
No parity
1 stop bit
Connecting a Terminal to the Catalyst 4000
Supervisor Engine I Console Port
The console port, shown in the figure below, is a data communications equipment (DCE) DB-25
receptacle that supports a DCE EIA/TIA-232 interface. EIA/TIA-232 supports unbalanced circuits at
signal speeds up to 64 kbps.
Figure: DCE DB-25 Connector
http://www.cisco.com/warp/public/473/9.html (13 of 19) [9/4/2003 12:36:03 PM]
RJ45-to-DB25
Adapter
RJ45
DB25 Pin
Pin
8
5
7
6
6
3
5
7
4
7
3
2
2
20
1
4
Terminal
(DTE)
Signal
CTS
DSR
RxD
GND
GND
TxD
DTR
RTS