Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Installation Note - Page 20

Browse online or download pdf Installation Note for Network Hardware Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 36 pages. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Also for Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Installation Note (14 pages), Solution Manual (17 pages), Installation Note (46 pages), White Paper (19 pages), Description (1 pages), Product Bulletin (6 pages), Notice (4 pages), Datasheet (9 pages), Datasheet (18 pages), White Paper (18 pages), Configuration Manual (8 pages), Installation Note (28 pages), Troubleshooting Manual (11 pages), Installation Note (18 pages), User Manual (17 pages), Installation Note (24 pages), Manual (19 pages)

Print Page
Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Installation Note
Removing a DFC4 Daughter Card
Partially reinstall a cap nut, rotating it about 3 turns so that there is a space of about 1/8 inch (3 mm)
Step 5
between the bottom of the cap nut and the top of the DFC4 daughter card, as shown in
cap nut acts as a stop when you unseat the daughter card connector so that the DFC4 daughter card does
not move horizontally and cause damage to the Ethernet module.
Figure 10
Appx 1/8 inch
With your left hand, lift slightly at the location shown in
Step 6
rock the DFC4 daughter card up and down with your right hand, no more than half an inch in either
direction, to unseat the DFC4 daughter card from the module.
Catalyst 6500 Series Distributed Forwarding Card 4 for WS-X68xx, WS-X69xx, and Select WS-X67xx Modules Installation Note
20
Partially Installing the Cap Nut
Cap nut
Figure
11. While lifting with your left hand,
Figure
10. The
OL-24918-02