Cisco 8540 - Catalyst Campus Switch Router Modular Expansion Base Troubleshooting Manual - Page 8
Browse online or download pdf Troubleshooting Manual for Network Hardware Cisco 8540 - Catalyst Campus Switch Router Modular Expansion Base. Cisco 8540 - Catalyst Campus Switch Router Modular Expansion Base 23 pages. Installing the controller
Also for Cisco 8540 - Catalyst Campus Switch Router Modular Expansion Base: Manual (11 pages)
Print Page
Configure/View CIMC IP from console during bootup
Retry Count: 7
Retry Interval (ms): 500
Volatile Bit Rate (kbps): 115.2
Non-Volatile Bit Rate (kbps): 115.2
Payload Channel: 14 (0x0e)
Payload Port: 623
>show imm chassis memory
Size: 8192 MB
Locator: DIMM_A1
Size: No Module Installed
Locator: DIMM_A2
Size: No Module Installed
Locator: DIMM_A3
Size: 8192 MB
Locator: DIMM_B1
Size: No Module Installed
Locator: DIMM_B2
Size: No Module Installed
Locator: DIMM_B3
Size: 8192 MB
Locator: DIMM_C1
Size: No Module Installed
Locator: DIMM_C2
Size: No Module Installed
Locator: DIMM_C3
Size: 8192 MB
Locator: DIMM_D1
Size: No Module Installed
>debug fastpath dump temperature
Debug command to see the Dataplane card temperature
FP0.21:Address of Temp sensor SA56004 is 4c
FP0.21:
Configured Temperature values:
FP0.21:Crit Remote/local=105,90
FP0.21:Status Reg= 0 Config =1 ,hysteresis=10
FP0.21:Octeon temp: 50.250 C, SA56004 temp: 25.750 C, Max/Min Temp = 55 / 0 C
FP0.21:
GPIO Stats:
FP0.21:Fan Status: Not Present
FP0.21:Temperature alert: Happened
Gives some advanced debugs for temperature related issue
Configure/View CIMC IP from console during bootup
Press F8 in the BIOS screen at the time of Bootup to view CIMC IP address configuration and to reset
password.
Choose either DHCP or Static config.
Step 1
Enter the VLAN tag if needed.
Step 2
Step 3
Enter the CIMC password.
Cisco 5520 and 8540 Wireless Controller Troubleshooting Guide
8
Remote High/Low = 85,0 Local High/Low = 85,0