Cisco Aironet 1430 Series Getting Started Manual - Page 31

Browse online or download pdf Getting Started Manual for Network Hardware Cisco Aironet 1430 Series. Cisco Aironet 1430 Series 48 pages. Wireless bridge

Print Page

correct, you can verify antenna alignment by using the RSSI port. The RSSI port can be used even when

the bridges are not associated. For additional information, refer to the "Aligning the Antenna Using

the RSSI Voltage" section on page 6.

Note

To meet regulatory restrictions, the external antenna bridge configuration and the external

antenna must be professionally installed.

For detailed alignment instructions, refer to the Cisco Aironet 1400 Series Wireless Bridge Mounting

Instructions that shipped with your bridge.

Resetting to the Default Configuration

If you forget the password that allows you to configure the bridge, you may need to completely reset

the configuration. You can use the MODE button on the power injector or the web-browser interface.

Note

The following steps reset all configuration settings to factory defaults, including passwords,

WEP keys, the IP address, and the SSID.

Using the MODE Button

Follow these steps to delete the current configuration and return all bridge settings to factory defaults

using the MODE button:

Disconnect the power jack on the power injector.

Step 1

Press and hold the MODE button while you reconnect power to the power injector.

Step 2

Hold the MODE button until the Status LED turns amber (approximately 3 seconds).

Step 3

After the bridge reboots, you must reconfigure the bridge by using the Web browser interface,

Step 4

the Telnet interface, or IOS commands.

The bridge is configured with the factory default values including the IP address (set

Note

to receive an IP address using DHCP). To obtain the bridge's new IP address, refer to

the "Using the IP Setup Utility" section on page 9.

THIRD FCC DRAFT (CISCO CONFIDENTIAL)