6
In the Select Components screen, make sure the client utilities that you want to install are
selected and any that you do not want to install are deselected. Click Next.
7
In the Select Program Folder screen, click Next to allow icons for the client utilities to be
placed in the Cisco Systems, Inc. folder.
8
In the Setup Complete screen, perform one of the following:
— If you selected no server-based authentication in Step 5, select Launch the Aironet
Client Utility and click Finish. ACU opens so you can configure your client adapter. If
you set a WEP key in CEM and enable WEP using ACU, the WEP key must match the
number and value of the WEP key used by the Access Point.
— If you selected LEAP or EAP server-based authentication in Step 5, select Yes, I want
to restart my computer now, remove the CD from your computer's CD-ROM drive,
and click Finish. When the computer reboots, enter your username and password at
the network logon screen. The client adapter will be authenticated and assigned a
session-based WEP key, provided your client adapter is configured to associate to an
EAP-enabled Access Point.
9
Refer to the Cisco Aironet Wireless LAN Adapters Software Configuration Guide for
8
instructions on how to use each utility.
Note
To install and use the client utilities on Windows NT or Windows 2000 systems, you
must log onto the system as a user with administrative privileges. The utilities do not install
or operate correctly for users not logged in with administrative rights.
Safety Information for the Cisco Aironet Wireless LAN Adapters
The Federal Communications Commission (FCC) with its action in ET Docket 96-8 has
adopted a safety standard for human exposure to RF electromagnetic energy emitted by FCC
certified equipment. Cisco Aironet 340 and 350 series products meet the uncontrolled
environmental limits found in OET-65 and ANSI C95.1, 1991. Proper operation of this radio
according to the instructions found in this manual and the hardware and software guides on
the Cisco Aironet Series Wireless LAN Adapters CD will result in user exposure that is
substantially below the FCC recommended limits.
•
Do not touch or move the antenna(s) while the unit is transmitting or receiving.
•
Do not hold any component containing a radio such that the antenna is very close to or
touching any exposed parts of the body, especially the face or eyes, while transmitting.
Print Page