Sony MEX-BT3800U - Bluetooth Audio System Operating Instructions Manual - Page 22
Browse online or download pdf Operating Instructions Manual for Stereo System Sony MEX-BT3800U - Bluetooth Audio System. Sony MEX-BT3800U - Bluetooth Audio System 44 pages. Bluetooth audio system
Also for Sony MEX-BT3800U - Bluetooth Audio System: Installation/Connections (2 pages), Limited Warranty (1 pages), Installation/Connections (2 pages), Specification Sheet (2 pages), Service Manual (50 pages)
4
If Passkey* input is required on the
display of the device to be connected,
input "0000."
A list of detected devices appears in the
display of the device to be connected. This
unit is displayed as "XPLOD" on the device
to be connected.
This unit and the Bluetooth device memorize
each other's information, and when pairing is
made, the unit is ready for connection to the
device.
Input passkey.
"0000"
-
-
~
xxxx ..,
-
-
~
0]
To use the Bluetooth function, the following
procedure is necessary.
Bluetooth (Handsfree calling
and Music streaming)
Bluetooth operations
Support site
http://esupport.sony.com
http://www.xplodsony.com/
o
Pairing
When connecting Bluetooth devices for the
first time, mutual registration is required. This
is called "pairing." This registration (pairing)
is required only for the first time, as this unit
and the other devices will recognize each
other automatically from the next time. You
can pair up to 8 devices. (Depending on the
device, you may need to input a passkey for
each connection.)
e
Connection
To use the device after pairing is made, start
the connection. Sometimes pairing allows to
connect automatically.
e
Handsfree callinglMusic streaming
You can talk handsfree and listen to music
when the connection is made.
•
22
Pairing
First, register ("pair") a Bluetooth device
(cellular phone, etc.) and this unit with each
other. You can pair up to 8 devices. Once pairing
is established, there is no need for pairing again.
1
Place the Bluetooth device within 1 m
(3 ft) of this unit.
2
Press and hold @) until"
0 "
flashes
(about 5 seconds).
The unit enters pairing standby mode.
flashing
3
Set the Bluetooth device to search for
this unit.
"0"
flashes and then stays lit after pairing is
complete.
S
Set the Bluetooth device to connect to
this unit.
"1iI~"
or
"f]~"
appears when the connection is
made.
*
Passkey may be called "passcode," "PIN code," "PIN
number" or "Password," etc., depending on the
device.
Note
Pairing standby mode
is
not released until the
connection
is
made.
About Bluetooth icons
The following icons are used by this unit.
lit:
Bluetooth signal on
0
flashing:
Pairing standby mode
off:
Bluetooth signal off
lit:
Connection successful
~~
flashing:
Connecting
off:
No connection
lit:
Connection successful
~~
flashing:
Connecting
off:
No connection