Argo VISION G20 Instruction Manual - Page 9

Browse online or download pdf Instruction Manual for Laminator Argo VISION G20. Argo VISION G20 12 pages.

Print Page

CLEANING THE COVER

1.
When the cover is dirty, use a soft wet cloth to clean it.
2.
Do not use solvents or petrol.
3.
Do not unscrew the cover to clean the rollers! It may cause electric shock!
HOW TO OBTAIN THE BEST RESULTS
1.
If your laminating pouch is not envelope-type it may be pulled in during the lamina-
tion. The use of laminating pouches other than recommended may cause trouble
during lamination.
2.
Lines or wrinkles may appear, if the laminating pouch is not placed straight.
3.
If the margin of the laminating pouch is wider then 3mm, pouches may fold on both
edges of the document.
4.
Laminated edges may not hold if the document is thicker than 300 mic.
5.
The lamination of documents of the thickness lower than 150 mic or the use of
laminating pouches of the thickness lower than 80 mic, especially cheap pouches
where the PET layer is thicker than 50 mic, may cause wrinkles. In such cases it is
advised to use a relatively low temperature (around 90ºC) or to use a carrier.
6.
If the laminated pouch is misty or does not show good gluing qualities, then you
need to use lower speed.
7.
If the laminated pouch is curved or wrinkled on the side, then you need to use
higher speed.
8.
Too high temperature may cause the pulling of the document into the rollers - use
the RELEASE button to release the document and clean the rollers from the glue.
9.
Remember to leave at least 50 cm space behind the machine for the laminated
documents.

TECHNICAL DATA

Laminating width
Laminating pouch thickness
Lamination speed
Warm-up time
Voltage
Dimensions
Net weight
© ARGO S.A.
EN
up to 320 mm (A3)
80-125 mic
480 mm/min
3-4 min
220-240 V / 50 Hz
470 x 116 x 98 mm
2,2 kgs
9
www.argo.pl