Sony MHC-DX70 Operating Instructions Manual - Page 16
Browse online or download pdf Operating Instructions Manual for Stereo System Sony MHC-DX70. Sony MHC-DX70 28 pages. Mini hi-fi component system
Print Page
Recording to a tape (continued)
Recording a CD by specifying
track order
— Program Edit
You can record tracks from all the CDs in the
order you want. When programing, make sure
the playing times for each side do not exceed
the length of one side of the tape.
1
Load a CD and a recordable tape into
deck B, then press CD.
2
Press PLAY MODE repeatedly until
"PROGRAM" appears in the display.
3
Press one of the DISC 1–3 to select a
CD.
To program all the tracks on a CD at once,
proceed to step 6 while "AL" appears in the
display.
4
Press . or > repeatedly until the
tracks you want appears in the display.
5
Press ENTER.
The track(s) is (are) programmed. The
program step number appears, followed by
the total playing time.
6
To program additional tracks, repeat
steps 3 to 5.
Skip step 3 to select tracks from the same
disc.
7
Press CD SYNC HI-DUB.
Deck B stands for recording. To reduce hiss
noise in low-level high frequency signals,
press DOLBY NR so that "DOLBY NR"
appears in the display. The REC PAUSE/
START button flashes.
8
Press DIRECTION to select g to
record on one side or j (or RELAY)
to record on both sides.
9
Press REC PAUSE/START.
Recording starts.
16
06TAP_MHC-DX70/DX50/RG80.p65 E
To
Cancel Program Edit
Clear a track from
the end
Tip
To check the required tape length for recording a CD,
press EDIT until "EDIT" flashes after you have
loaded a CD and pressed CD. The required tape
length for the currently selected CD appears, followed
by the total playing time for side A and side B
respectively (Tape Select Edit).
Note
You cannot use Tape Select Edit for discs containing
over 20 tracks.
Timer-recording radio
programs
To timer-record, you must preset the radio
station (see "Presetting radio stations" on
page 12) and set the clock (see "Setting the
time" on page 8) beforehand.
1
2
3
4
16
MHC-DX70/DX50/RG80 4-232-650-13 (1)
Press
PLAY MODE repeatedly
until "PROGRAM" or
"SHUFFLE" disappears
from the display.
CLEAR on the remote in
stop mode.
Tune in the preset radio station (see
"Listening to the radio" on page 13).
Press CLOCK/TIMER SET on the
remote.
"DAILY 1 SET" appears.
Press cursor V/v repeatedly to select
"REC SET", then press ENTER.
"ON" appears and the hour indication flash
in the display.
Set the time to start recording.
Press cursor V/v repeatedly to set the hour,
then press ENTER.
The minute indication starts flashing.
Press cursor V/v repeatedly to set the
minute, then press ENTER.
The hour indication flashes again.
3/13/01, 4:50 PM