Sony STR-DA333ES - Fm Stereo/fm-am Receiver Technical Background - Page 14
Browse online or download pdf Technical Background for Stereo System Sony STR-DA333ES - Fm Stereo/fm-am Receiver. Sony STR-DA333ES - Fm Stereo/fm-am Receiver 38 pages. Fm stereo fm-am receiver
Also for Sony STR-DA333ES - Fm Stereo/fm-am Receiver: Limited Warranty (1 pages), Service Manual (18 pages)
Print Page
be isolated from other circuits. On big amps, you'll usually find the output
transistors bonded to heavy aluminum heat sinks somewhere at the back or
sides of the chassis. Thanks to the cool running of Sony's S-Master Pro
amplifier, the MOS FETs are located where the circuit topology is shortest and
simplest—lined up side-by-side, right in the middle of the power amplifier circuit
board. In fact, the transistors can be so close together that the STR-DA7100ES
amplifier section is some 70% smaller than the DA9000ES amp section! And the
board itself is located in the middle of the DA7100ES chassis.
As a result, the music is less exposed to vibration, radiated hum and
noise. Operation is cool and consistent. And nothing intrudes between you and
the sound.
Transistor heat
Transistor packing
Transistor location
Transistor heat radiation
Heat sinks
Space requirements
Amplifier board location
Overall chassis topology
Even inside the MOS FET output transistors, Sony innovations are at
work. Sony uses a new refinement of our molecular bonding technique to attach
the transistor leads. In the STR-DA9000ES, the MOS FETs use "double wire
molecular bonding" with two bonding wires, each rated for 15 amps of current.
As a result, the DA9000ES MOS FET binding wires had 30 amp capacity. This
was sufficient for the transistor's rated instantaneous current supply of 24 amps.
The bare transistor for the STR-DA9000ES MOS FET, showing the
double wire molecular bonding.
ES Receivers v1.0
Traditional amplifier
Major design concern
Widely separated
Away from heat-sensitive parts
From the bottom
Massive radiating fins made of
die cast aluminum (on the
better amplifiers)
Major, for high powered
amplifiers
Isolated, to protect other
circuits from heat
Circuitous, because of output
transistor heat
Molecular Bonding
STR-DA7100ES
Minor issue
Close together
Surface mount directly on the
amplifier circuit board
From the top
A single sheet of metal
70% smaller than the STR-
DA9000ES—and far, far
smaller than analog amps of
comparable power
Wherever it makes the most
sense for the shortest possible
signal paths
Short, simple and straight
Page 14